fridge - freezer INSTRUCTION BOOK ERF 2830 © Electrolux plc 2002 2222 122-47
IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety.
Should the lining up of the furniture door be necessary, use the clearance of slots. CONTENTS At the end of operations, it is necessary to check if the door of the furniture closes properly.
Separate parts A, B, C, D as shown in the figure OPERATION B A Before using Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). C D Do not use soap or detergent as the smell may linger. Dry thoroughly. PR266 Setting the temperature The temperature inside the refrigerator and the freezer is regulated by a single thermostat with 6 temperature positions and an “OFF” (O) position.
Push appliance into housing until stop strip (A) touches the kitchen unit. A Frozen food storage Making ice cubes When you first start the freezer or if the freezer has been out of use for some time, we advise you to depress the ambient switch for at least two hours before storing frozen food. The appliance is provided with one plastic ice cube tray. Do not exceed the storage period indicated by the manufacturer. To turn out the ice cubes simply give the tray a slight twist to release the cubes.
Movable shelves Instructions for totally built-in appliances The walls of the refrigerator have runners so that the shelves can be positioned as desired . For better use of space, the front half-shelves can lie over the rear ones. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height.To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes off, then reposition as required.
Electrical connections The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. WARNING: THIS APPLIANCE MUST BE EARTHED.
MAINTENANCE AND CLEANING INSTALLATION Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Important Warning IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly.
TECHNICAL SPECIFICATIONS SOMETHING NOT WORKING POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 160 W AVERAGE DAILY UNITS ELECTRICITY * 1.15 kWh GROSS CAPACITY Fridge 214 l Freezer 68 l NET CAPACITY Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee.
During a normal night time period of approximately 8 hours a traditional fridge freezer can normally maintain the frozen food temperature but if the appliance is left for longer period in a low ambient the freezer will defrost . If, after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.
