user manual Refrigerator ERES38820W ERES38820X
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 components of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a shortcircuit, fire and/or electric shock.
electrolux ried out by a qualified electrician or competent person. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
electrolux 5 Temperature regulation The temperature may be changed by pressing the button (B). The current temperature setting flashes and by pressing button (B) again the set temperature is possible to change in steps of one degree. The selected-temperature will be reached within 24 hours. Functions Menu By activating the button (D) the functions menu is operating. Each function could be confirmed by pressing button (E).
electrolux dicator shows the letter H. It is possible to de-activate the function at any time by changing the selected temperature in the compartment. • flashing icon • acoustic buzzer When normal conditions are restored (door closed), the alarm will stop. During the alarm phase, the buzzer can be switched off by pressing button (E). Warning! The fridge compartment must be empty with Holiday function on. Door open alarm An acoustic alarm will sound if the door is left open for a few minutes.
electrolux 7 Permanent unlocking Press buttons 2 and 3 at the same time for about three seconds. The button 2 or 3 lights up to indicate unlocking and the child lock indicator (1) goes out. To activate the child lock function Press buttons 2 and 3 at the same time for about three seconds. The child lock indicator is lit when activated. Selecting and dispensing water Before dispensing water, select either carbonated water (2) or plain water (3). The actual choice is indicated by the lit button.
electrolux DAILY USE Use of the fridge compartment The temperature of this compartment may be regulated between +2°C and +8°C. During normal functioning the indicator shows the set temperature. A medium setting is generally the most suitable. The exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the door is opened • the quantity of food stored • the location of the appliance.
electrolux 9 gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Important! Do not move the lower door shelf to ensure correct air circulation. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights.
electrolux Important! Do not place food against or close to the temperature sensor. This can result in too cold temperatures. measuring shall be performed under steady-stated conditions (without changing the load). • If you want to check the temperature of food stored in the refrigerator, place a glass of water centrally in the cabinet, and put a proper thermometer with an accuracy of +/– 1 °C into it. After 6 hours the temperature can be monitored.
electrolux 11 Remove the filter. A small amount of water will run out. Dry off and fit the new filter. Refer to "Installation of the water filter" Replacement filters can be ordered from Electrolux Service Force Centre, The water connection does not need to be switched off when changing the filter. Replacing the gas cylinder Remove the gas cylinder, refer to "Installation of the gas cylinder" The replacement gas cylinder is obtained through your local dealer.
electrolux given about them to avoid unnecessary charges on service. Important! The operation of the appliance goes with certain sounds (compressor and circulating sound). This not means a trouble, but a normal operation. Problem Important! The appliance operates discontinuously, so the stopping of compressor does not mean being no current. That is why you must not touch the electrical parts of the appliance before breaking the circuit. Possible cause Solution The appliance is noisy.
electrolux 13 Problem Possible cause Solution The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a another electrical appliance to the mains socket. Check fuse. Contact a qualified electrician. Not enough carbon dioxide in the water. The carbon dioxide is running out. Refer to "Installation of the gas cylinder". Too much carbon dioxide in the water.
electrolux TECHNICAL DATA ERES38820W ERES38820X Dimension Height 1800 mm 1800 mm Width 595 mm 595 mm Depth 650 mm 650 mm Voltage 230 V 230 V Frequency 50 Hz 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Water pressure range The water pressure must be at least 1 bar (100kPa) Consult your installer if water pressure is less than 1 bar.
electrolux 15 50mm 3 2 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician.
electrolux been correctly carried out, that there is no leakage at the connection to the water tap. Tighten the screw enough by hand. Make sure that the gasket is properly positioned in the connector. We recommend that the appliance is placed on a "run-off" mat intended for refrigerators and freezers, which makes it easier to detect possible leakage 3. Insert the filter in the slot found in the back of the air lever flap. Levelling When placing the appliance ensure that it stands level.
electrolux 17 3. Pull the bypass cartridge outwards, grasping the lower part, until the water bypass cartridge is automatically ejected. 9. Unlock the water dispenser. Refer to "Child lock functions". Select plain water and dispense about 2 litres of water. There may be some air to start with. Installation of the gas cylinder 1. Remove the gas cylinder wrapping and screw on the adapter to the gas cylinder. Tighten by hand only. 4.
electrolux 2. Position the gas cylinder with the adapter attached underneath the valve and ensure that the hooks of the lever system supports the protruding parts of the adapter. 3. Then turn the lever upwards in one continuous movement. 2 Refer to Installation Guide. 1 Door reversibility It is not possible to change the opening direction of the door. The water supply goes through the hinge to the water dispenser. Contact your dealer for more information.
electrolux 19
www.electrolux.
