user manual Refrigerator ERES38820X
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 components of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a shortcircuit, fire and/or electric shock.
electrolux ried out by a qualified electrician or competent person. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
electrolux 5 Temperature regulation The temperature may be changed by pressing the button (B). The current temperature setting flashes and by pressing button (B) again the set temperature is possible to change in steps of one degree. The selected-temperature will be reached within 24 hours. Functions Menu By activating the button (D) the functions menu is operating. Each function could be confirmed by pressing button (E).
electrolux dicator shows the letter H. It is possible to de-activate the function at any time by changing the selected temperature in the compartment. • flashing icon • acoustic buzzer When normal conditions are restored (door closed), the alarm will stop. During the alarm phase, the buzzer can be switched off by pressing button (E). Warning! The fridge compartment must be empty with Holiday function on. Door open alarm An acoustic alarm will sound if the door is left open for a few minutes.
electrolux 7 Permanent unlocking Press buttons 2 and 3 at the same time for about three seconds. The button 2 or 3 lights up to indicate unlocking and the child lock indicator (1) goes out. To activate the child lock function Press buttons 2 and 3 at the same time for about three seconds. The child lock indicator is lit when activated. Selecting and dispensing water Before dispensing water, select either carbonated water (2) or plain water (3). The actual choice is indicated by the lit button.
electrolux DAILY USE Use of the fridge compartment The temperature of this compartment may be regulated between +2°C and +8°C. During normal functioning the indicator shows the set temperature. A medium setting is generally the most suitable. The exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the door is opened • the quantity of food stored • the location of the appliance.
electrolux 9 gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Important! Do not move the lower door shelf to ensure correct air circulation. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights.
electrolux Important! Do not place food against or close to the temperature sensor. This can result in too cold temperatures. measuring shall be performed under steady-stated conditions (without changing the load). • If you want to check the temperature of food stored in the refrigerator, place a glass of water centrally in the cabinet, and put a proper thermometer with an accuracy of +/– 1 °C into it. After 6 hours the temperature can be monitored.
electrolux 11 Replacing the gas cylinder Remove the gas cylinder, refer to "Installation of the gas cylinder" The replacement gas cylinder is obtained through your local dealer. Cleaning the water dispenser When necessary, clean the surfaces of the dispenser, using only a soft cloth and warm water. The dispenser drip tray can be cleaned with a lukewarm water and some neutral soap. Lime deposits on the dispenser surface can removed using vinegar or diluted acetic acid as cleaning agent.
electrolux Problem Possible cause Solution Sound level is too high during dispensing of water. The transport supporting tie of the water system pressure pump has not been removed. Remove the tie. Refer to "Removing the transport support". The buzzer sounds. The Alarm icon flashing. The door is not closed correctly. Refer to "Door open alarm". upper or lower square is shown in the temperature display.
electrolux 13 Problem Possible cause Solution Not enough carbon dioxide in the water. The carbon dioxide is running out. Refer to "Installation of the gas cylinder". Too much carbon dioxide in the water. Dilute with ordinary water. Refer to "Selecting and dispensing water". No carbon dioxide. The gas cylinder is empty. Refer to "Replacing gas cylinder" No or very low water flow. The gas cylinder is empty. Refer to "Replacing gas cylinder". Sediment in the water.
electrolux TECHNICAL DATA Dimension Height 1800 mm Width 595 mm Depth 650 mm Voltage 230 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Water pressure range The water pressure must be at least 1 bar (100kPa) Consult your installer if water pressure is less than 1 bar.
electrolux 15 50mm 3 2 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician.
electrolux Installation of the Taste Guard filter The Taste Guard filter is an active carbon filter which absorbs bad odours maintain the best flavour and aroma for all foodstuffs without risk of odour cross contamination. On delivery the carbon filter is in a plastic bag to preserve performance. 1. Open the air lever flap. Connecting the water hose. Water supply should be provided with a tap and 3/4" male connector within 1,5 m from the appliance. This work is to be carried out by a skilled plumber.
electrolux 17 Starting the water system for the first time. Ensure proper connection to the water supply, refer to "Connecting the water hose". 1. Open the tap on the water connection. 2. Start the refrigerator (switch off and restart if it is already running). 3. Unlock the water dispenser. Refer to “Child lock functions”. Select plain water and dispense about 2 litres of water. There may be some air to start with. The water system main valve opens and the pump starts to fill the system. 2.
electrolux Door reversibility It is not possible to change the opening direction of the door. The water supply goes through the hinge to the water dispenser. Contact your dealer for more information. ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
electrolux 19
www.electrolux.
