refrigerator/frigorifico/réfrigérateur/ INSTRUCTION BOOKLET INSTRUCCIONES DE USO ISTRUÇÕNES DE USO GB ERES3500, ERES3500X GB ES 818 38 21--01/9 PT
Safety instructions GB Your new fridge may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. Your safety is of paramount importance.
Installation of carbon filter . . . . . . . . . . . . . . . . . . . 14 Installation . . . . . . . . . . . . . . . . . . . . . . . . 13 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Remove the transport supports . . . . . . . . . . . . . . . . Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connecting the water hose . . . . . . . . . . . . . . . . . . . . Electrical cord . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Control Panel (water dispenser) H I M L N H. Yellow indicator lamp Lights up when the locking function has been activated. I. Button for carbonated water. - Used for the choice of carbonated water. - For the engagement and disengagement of the locking function. J. Button for ordinary water. - Used for the choice of ordinary water. - Switches the background lighting on and off. K J - Switches off the indicator lamp for water filter replacement. K.
It is not necessary to reset the temperature when the cabinet is switched on after it has been out of use. The thermostat recalls the previously set temperature. Temperature inside the fridge A suitable temperature inside the fridge is approx. +5°C. Storage temperature in the cabinet is even on all of the shelf levels. The vegetable box which is placed in the bottom has a temperature of 3-4°C warmer than the intended temperature setting.
Carbon filter's function: The built-in carbon filter means that strong smelling groceries can be placed near other groceries without affecting their taste or aroma. The functions of the water dispenser The locking function: The locking function is activated by the production plant. For temporary unlocking: Keep the button (I) or (J) pressed in for about three seconds until the yellow indicator lamp (H) goes out. The locking function is re-activated automatically after about three seconds.
Indicator lamp for the water filter: The water dispenser is fitted with an indicator lamp (K) which shows when it is time to change the water filter. When the indicator lamp stays on, then the water filter has been utilised to about 80 % of its expected lifetime. In this situation, it is recommended that you buy a replacement filter. When the indicator lamp starts flashing, the water filter has been utilised to 100% of its lifetime. Replace the filter without delay.
Quick chill shelf: The lower Quick chill shelf can be placed in one of the upper grooves. To maintain the best performance the shelf should be placed in the second groove from the top. Dismantling of the bottle-- and can holder. Take out the Quick Chill shelf with holder from the cabinet. To loosen the holder from the shelf, bend the hooks/brackets that surround the backside of the shelf. Hints and Tips GB Saving energy compartment.
Cleaning Clean the cabinet at regular intervals. Don't use detergents, abrasive powders, high perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol when cleaning the product Internal Cleaning Disconnect the appliance from electricity supply. Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0,5 litre water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris.
Service during operation The water filter is replaced as follows: Place a piece of kitchen tissue or a dishcloth in the space under the filter. Remove the filter by turning it clockwise. A small amount of water will run out. Dry off and fit the new filter. See the section "When starting the water system for the first time". The water connection does not need to be switched off when changing the filter. Replacement filters can be ordered from Electrolux Service Force Centre.
Something Not Working GB Before contacting your local Service Force Centre check the following point: Problem Possible cause / Remedy " " is displayed in the temperature display. An error has occurred in measuring the temperature. Call your service representative. (The cooling system will continue to keep food products cold, but temperature adjustment will not be possible.) It is too warm inside the refrigerator. Set a lower temperature. Put food products in the right place inside the refrigerator.
Water flow very low Remove and clean the strainer in the connecting valve. Sediment in the water. Replace the filter or install a pre-filter. Only gas comes out when opening Incoming water pressure too high. Install a pressure-limiting device. Capacity temporarily exceeded. Wait for ten minutes. The water dispenser lamp flashes Leakage at the water connection. Remedy the leakage and empty the box by pulling out the red plug. See the illustration in "Connecting the water hose".
Permissible water pressure (to ensure reliable function). The total flow in the system can vary, depending on local water conditions and/or water pressure. Lowest permissible water pressure. 2,5 bar (250kPa) Highest permissible water pressure. 5 bar (500kPa) Consult your installer if water pressure is less than 2,5 bar. If water pressure exceeds 5 bar, than a reduction valve must be fitted (available from your specialist shop).
Connecting the water hose. The water coupling is connected to a water tap with an external 3/4 inch thread. This work is to be carried out by a skilled plumbing installation technician. The refrigerator is to be connected with a shut-off cock. There are different type-approved taps and tap assemblies on the market. The water hose must not be cracked, squeezed or be in tight bends. If you require a longer water hose than that supplied, then a VDE-approved 150 38 85-02/0 supply hose should be used.
Installing the cabinet When two appliances are placed beside each other, the distances enclosed in the plastic wrapping should be glued between the appliances. As shown in the illustration. To obtain the best performance from the cabinet, ensure : · the cabinet is placed in a dry, cool place and is not exposed to direct sunlight. · the cabinet is not placed close to a source of heat, e.g. a cooker or dishwasher. · the cabinet is level. The cabinet should not lean against any wall.
When the water system is started for the first time. The following should be carried out when the refrigerator is correctly connected to the water supply in the building: Open the tap on the water connection and start up the refrigerator. The water system main valve opens and the system starts to fill up. Wait for five minutes.
www.electrolux.
