user manual Fridge-Freezer ERD176C ERD176S
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 damage to the cord may cause a shortcircuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4.
electrolux Service • Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
electrolux 5 Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
electrolux HELPFUL HINTS AND TIPS Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption.
electrolux 7 charging must therefore only be carried out by authorized technicians. Periodic cleaning The equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. Important! Do not pull, move or damage any pipes and/or cables inside the cabinet.
electrolux Periods of non-operation When the appliance is not in use for long periods, take the following precautions: • disconnect the appliance from electricity supply • remove all food • defrost 5)and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.
electrolux 9 Problem Possible cause Solution The temperature regulator is not set correctly. Set a lower temperature. The door is not closed correctly. Refer to "Closing the door". The product temperature is too high. Let the product temperature decrease to room temperature before storage. Many products are stored at the same time. Store less products at the same time. The temperature in the refrigerator is too high. There is no cold air circulation in the appliance.
electrolux TECHNICAL DATA Dimension Height 1750 mm Width 600 mm Depth 645 mm Rising Time 25 h The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Warning! It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
electrolux 11 Slacken the screws and insert the spacer under the screw head, then retighten the screws. H Door reversibility Before carrying out any operations, remove the plug from the power socket. To change the opening direction of the door, proceed as follows: • To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations. • Open the door . Unscrew the screws and remove the center hinge (H).
electrolux • Re-insert the cover (e) on the opposite side. • Re-insert the lower door on the pivot pin (f). e 2 1 5 f 4 3 • Remove the 2 plastic covers and refit it on the opposite side. • Insert the pivot of the center hinge on the left hole of the lower door. • Insert the lower door on the pivot of the lower hinge (f). • Insert the upper door on the pivot of the upper hinge. Rotate the doors to insert the pivot of the hinge in the left hole of the upper door.
electrolux 13
electrolux
electrolux 15
www.electrolux.
