user manual Refrigerator ERC37320W
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Control panel First use Daily use Helpful hints and tips 2 4 4 5 6 Care and cleaning 7 What to do if… 8 Technical data 10 Installation 10 Environmental concerns 13 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
electrolux 3 damage to the cord may cause a shortcircuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3.
electrolux Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appli- ance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
electrolux 5 DAILY USE Movable shelves The walls of the refrigerator are equipped with a series of shelves support so that the shelves can be positioned as desired. Some shelves must be lifted up by the rear edge to enable them to be removed. Important! Do not move the glass shelf above the vegetable drawer to ensure correct air circulation. Vegetable Drawer The drawer is suitable for storing fruit and vegetables.
electrolux Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Important! Do not move the big lower door shelf to ensure correct air circulation.
electrolux 7 This results in colder temperature in the lower part of the fridge due to the cold air that falls down. It may result in that food with high water content start to freeze. If too cold, change to a higher temperature setting. Important! Do not place any shelves towards the water drain hole. This can result in too cold temperatures.
electrolux Defrosting the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a drain hole into a special container at the back of the appliance, over the motor compressor, where it evaporates.
electrolux 9 Problem Possible cause Solution The appliance is noisy. The appliance is not supported properly. Check if the appliance stands stable (all feet and wheels should be on the floor). Refer to "Levelling". The compressor runs continuously. The Temperature regulator may be set incorrectly. Set a warmer temperature. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary.
electrolux Problem Possible cause Solution The appliance has no power. There is no voltage in the mains socket. Connect a another electrical appliance to the mains socket. Check fuse. Contact a qualified electrician. The lamp does not work. The lamp is defective. Refer to "Replacing the lamp". Door interferes with ventilation grill. The appliance is not levelled. Refer to "Levelling". Misaligned door. The appliance is not levelled. Refer to "Levelling".
electrolux 11 Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Location To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 40 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. The ventilation space can be: • directly above the appliance • behind and above the top cupboard.
electrolux 2. Remove the ventilation grille. Remove the upper filling and install it on the opposite side of the grille. Remove the pedal hole cover and install the cover provided in the accessory bag on the opposite side. 3. Lay down the appliance back side down on a wooden support. 4. Unscrew the hinge (B1) and remove the cover plate (B2) and the support (B3). Remove the cover (B4) on the opposite side and install the support (B3) the cover plate (B2) and the hinge (B1).
electrolux 13 7. Unscrew the handle. On the opposite side remove the hole covers by driving a 3–4 mm drift or drill into them. Install the handle. Install the hole covers provided within the accessory bag. 9. Put the appliance in position. Warning! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly.
electrolux
electrolux 15
www.electrolux.
