fridge - freezer INSTRUCTION BOOK ERB 3225 X © Electrolux plc 2005 2223 374-81
IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety.
CONTENTS Instructions for the User Important Safety Information 2 Instructions for the Installer Operation 4 Technical Specification 13 Before use 4 Installation 14 Control panel 4 Positioning 14 Starting your appliance 4 Shelf holders 14 Temperature control 4 Electrical Connection 15 Ambient Temperature Switch 4 The freezer compartment 4 Rear Spacers 16 Freezing fresh food 4 Door Reversal 16 Frozen food storage 5 Thawing 5 Making ice cubes 5 Cold accumulators 5 Fres
OPERATION Before using Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Control panel N-S AB ON C D A. Pilot light for ambient temperature switch B. Ambient temperature switch Starting your appliance Insert the plug into the wall socket. The thermostat control knob (D) will pre-set and the operating pilot light (C) will illuminate.
Rear spacers Frozen food storage In the bag with the documentation, there are two spacers which must be fitted as shown in the figure. When first starting-up or after a period of use, before putting the products in the compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal opertion position. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws.
Movable shelves Electrical connections The walls of the refrigerator have runners so that shelves can be positioned as desired. D338 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To do this proceed as shown in the diagram. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The plug must not be used if the fuse cover/carrier is lost.
HINTS AND TIPS INSTALLATION Important IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Positioning Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal”.
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Internal cleaning TECHNICAL SPECIFICATIONS Changing the light bulb If it becomes necessary to replace the lamp, press on the rear hook and at the same time slide the cover in the direction indicated by the arrow. DIMENSIONS Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly.
GUARANTEE CONDITIONS Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops.
SOMETHING NOT WORKING SERVICE AND SPARE PARTS Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee.
SOMETHING NOT WORKING SERVICE AND SPARE PARTS Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee.
GUARANTEE CONDITIONS Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops.
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Internal cleaning TECHNICAL SPECIFICATIONS Changing the light bulb If it becomes necessary to replace the lamp, press on the rear hook and at the same time slide the cover in the direction indicated by the arrow. DIMENSIONS Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly.
HINTS AND TIPS INSTALLATION Important IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Positioning Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal”.
Movable shelves Electrical connections The walls of the refrigerator have runners so that shelves can be positioned as desired. D338 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To do this proceed as shown in the diagram. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The plug must not be used if the fuse cover/carrier is lost.
Rear spacers Frozen food storage In the bag with the documentation, there are two spacers which must be fitted as shown in the figure. When first starting-up or after a period of use, before putting the products in the compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal opertion position. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws.
fridge - freezer INSTRUCTION BOOK ERB 3225 X © Electrolux plc 2005 2223 374-81
