user manual Refrigerator ERA37320W ERA37320X
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Control panel First use Daily use Helpful hints and tips 2 4 4 5 6 Care and cleaning 7 What to do if… 8 Technical data 10 Installation 10 Environmental concerns 13 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
electrolux 3 • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a shortcircuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance.
electrolux Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appli- ance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
electrolux 5 DAILY USE Movable shelves The walls of the refrigerator are equipped with a series of shelves support so that the shelves can be positioned as desired. Some shelves must be lifted up by the rear edge to enable them to be removed. Important! Do not move the glass shelf above the vegetable drawer to ensure correct air circulation. Vegetable Drawer The drawer is suitable for storing fruit and vegetables.
electrolux Air circulation The refrigerator compartment is equipped with a D.A.C. (Dynamic Air Cooling) fan which enables rapid cooling of foods and a more uniform storage temperature. It is suggested to activate D.A.C when the ambient temperature exceeds 25°C. Set the switch (A) to the On position and the fan runs when the compressor is running. gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
electrolux 7 aluminium foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Hints for temperature inside the fridge • A suitable temperature inside the fridge is approx. +5° C. It is normal with higher temperature in the top of the fridge and lower temperature in the lower part.
electrolux Important! Do not use detergents or abrasive paste as these will damage the paint, or stainless steel anti finger print coating. refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. After cleaning, reconnect the equipment to the mains supply. Cleaning the ventilation grille The ventilation grille can be removed for washing. Make sure the door is open and then: 1. Loosen the upper edge of the grille by pulling outward/downward. 2.
electrolux 9 Problem The compressor runs continuously. Possible cause Solution The Temperature regulator may be set incorrectly. Set a warmer temperature. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The food temperature is too high. Let the food temperature decrease to room temperature before storage. The room temperature is too high. Decrease the room temperature.
electrolux Problem Possible cause Solution The lamp does not work. The lamp is defective. Refer to "Replacing the lamp". Door interferes with ventilation grill. The appliance is not levelled. Refer to "Levelling". Misaligned door. The appliance is not levelled. Refer to "Levelling". As much as the advice does not lead to result, call the nearest brand-mark service. Replacing the lamp 1. Disconnect the appliance from the power socket. 2. Fold the lamp cover backward by loosen the front edge.
electrolux 11 wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 40 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. The ventilation space can be: • directly above the appliance • behind and above the top cupboard. In this case, the space behind the top cupboard must be at least 50 mm deep. 3. Remove the transport support from the lower hinge (some models).
electrolux Install the spacers on the back side of the panel. 4. Unscrew the hinge (B1) and remove the cover plate (B2) and the support (B3). Remove the cover (B4) on the opposite side and install the support (B3) the cover plate (B2) and the hinge (B1). Install the cover (B4) on the opposite side. B1 B2 B3 B4 Levelling When placing the appliance ensure that it stands level. If necessary adjust the feet using the adjustment spanner supplied.
electrolux 13 7. Unscrew the handle. On the opposite side remove the hole covers by driving a 3–4 mm drift or drill into them. Install the handle. Install the hole covers provided within the accessory bag. 9. Put the appliance in position. Warning! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly.
electrolux
electrolux 15
www.electrolux.
