A\ IMPORTANT SAFETY INFORMATION Read carefully the user instructions, with the directions, advice and cautionary notes, before installing the cabinet and using it. It will then perform satisfactorily and give maximum benefit, Anyone using the cabinet must be familiar with how it should be used. Save these user instructions. Keep them where they are easy to find. They contain many items of advice that will enable you 1o use the cabinet correctly.
ENVIRONMENTAL CONCERNS + The insulation and refrigerant in the unit are completely free from ozone depleting chlorine and totally harmless to the ozone layer. + Al parts of the packaging can be recycled. + The cabinets are manufactured so that they can easily be dismantled for recovery. » Hand over the scrapped fridges and freezers to a recycling company.
INSTALLATION Unpacking and damage in transit inspect the cabinet for damage. Immediately advise your supplier of any damage that may have occurred in transit Hand the packaging over for recycling. A\ Don't let children play with the packaging. The plastic film has been known to cause suffocation. Cleaning First wash the inside of the cabinet with a mild washing-up detergent. Don use strong or abrasive cleaning agents, steer wool, abrasive sponges or solvents. Leave the cabinet to dry thoroughly.
Before pushing the power supply plug into the socket and starting the cabinet for the first time, leave it standing upright for about 30 minutes or for about 4 hours if it was transported horizontally. The liquid in the refrigeration system will then have time to stabilize. if this is not observed, the compressor may sustain damage.
USING THE FRIDGE ) mAx Penguin ) b a. Green indicator lamp Lights up when the fridge iz operating. b. Thermostat control. Stemless regulation Lowest sifting, minimum cold Min rifest sifting, maximum cold Max Off u Starting, setting the temperature Start the fringe by turning the thermostat knob to a medium position, L.e. until the marking on it points straight down. Then set it to the desired temperature by trial and error. The temperature set on the thermostat will then be maintained automatically.
Practical advice Storing foods in the fridge Place the various items slightly separated, so that cold air will be able to circulate freshly between them. Never place food against the cold evaporator plate on the rear wall. — The products may be too cold and may freeze or be damaged by frost. — Lint from food packages may breeze to the evaporator plate and may then clog the drip channel and defrost water hose.
CARE AND MAINTENANCE Defrosting (0 The fridge is defrosted automatically every time the come presser stops. The layer of frost that has formed on the evaporator plate on the rear wall will then thaw. The water is discharged through a hose at the rear of the cabinet into a drip tray on the compressor, where it will evaporate. Clean the drip channel in the cabinet at regular intervals to prevent it from clogging.
IF THE APPLIANCE DOES NOT PERFORM CORRECTLY if the unit does not appear to work correctly, you may be able 1o attend to the fault yourself. Before calling a serviceman, carefully read and follow the information and advice below, to make sure that you will not be calling out the serviceman unnecessarily. The inside of the cabinet is not cold enough * Reset the thermostat to a lower temperature (colder) + Place the food in the correct places in the fridge.
GUARANTEE, SERVICE AND SPARE PARTS Read the user instructions and follow the advice and directives given. In many cases, you will be able to clarify any doubts yourself and thus avoid unnecessary service calls. The preceding section entitled “If the appliance does not perform correctly” includes suggestions for what should be sacked before a serviceman is called. If, after the above check, there is still a fault cal your nearest Electrolyte Service Center.
