I N I N S T R U C T I O N REFRIGERATOR 2222682-51 F O B O O K L E T ER 6436 U
CONTENTS Instructions for the User Instructions for the Installer Important Safety Instructions 3 Technical Specifications 13 Description of the Appliance 4 Installation 13 Operation 4 Before use Setting the temperature Fresh food refrigeration The door shelves Normal Operating Sounds 4 4 5 5 5 Health and safety guidelines 6 Defrosting 6 Maintenance and Cleaning 7 Internal cleaning Periodic cleaning Changing the light bulb When the appliance is not in use 7 7 7 7 Something not Working?
IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation ■ General Safety Check the appliance for transport damage. Under no circumstance should a damaged appliance be installed. In the event of damage please contact your retailer.
■ When unplugging always pull the plug from the mains socket, do not pull on the cable. At the end of the Appliance Life Servicing ■ This product should be serviced by an authorised engineer and only genuine spare parts should be used. ■ Under no circumstances should you attempt to repair the appliance yourself. Repairs carrier out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Force Centre.
Important If the fridge is not defrosting correctly, it is possible that because a very low temperature has been selected, the motor is working continuously, which prevents the defrost cycle from operating. During prologed periods of abnormally hot weather, if the thermostat is set on too high a number, the cooling system may operate continuously and the fridge cooling plate may not defrost. Turning the knob to a lower number will cause the automatic defrosting to resume.
HEALTH AND SAFETY GUIDELINES Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible. ■ Keep the time between buying chilled food and placing it in your fridge as short as possible.
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Changing the light bulb Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. 1.
SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown.
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Electrolux Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Centre covering your post code area. The addresses are listed on the following pages.
GUARANTEE CONDITIONS Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ■ The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth 81,5 59,6 53,8 POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY(*) 220-240 V / 50 Hz 70 W 0,49 kWh GROSS CAPACITY 142 l NET CAPACITY 140 l cm cm cm (*)This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located.
ELECTRICAL CONNECTION This appliance complies with the E.E.C. Directive No. 87/308 of 2.6.87 relative to radio interference suppression. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. This appliance complies with the following E.E.C. Directive: If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. - 73/23 EEC of 19.2.
BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Door Reversal Left door opening: A 1. Remove the grid from the appliance pulling it towards you with hands. 2. Remove the left side (A) of the grid cutting it from the rear (see figure). DO002 To reposition the grid on the appliance proceed as follows: Apply the grid to the base of the appliance by pushing the clasps (a) until they click. a N.B.
To reverse the opening direction of the door, proceed as shown in the figures: Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. 60 0 5 min50 . 600 DO013 Remove covering and adjusting strips. Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. S.I.005 Adjust height.
To mount the furniture door proceed as shown in the figures: 18
Screw appliance into place. Refit the covering strip. Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. ■ 580 25 25 Important DO008 The plinth must be positioned at a minimun distance of 25 mm from the door. 19 a = 100 b = 150 ■ For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments.
© Electrolux Household Appliances Limited 2000
