Important information about safety Read carefully through the instructions with ail necessary directions for use, advice and cautionary notes before installing the cabinet and using it The cabinet will then give satisfactory service and you will gain the maximum benefit from it All persons using the cabinet must be thoroughly familiar with its operation and safety features.
under, behind and on top of the cabinet must not be blocked. If the appliance is set under a wall cabinet, the top of the appliance should be at least 75 mm (200 cm? away from the base of the cabinet. The Electrical Connections If the plug that is fitted to your appliance is not suitable for your socket outlet, @ must be cut off and the appropriate plug fitted.
Set the main switch to L. Start the freezer by muting the thermostat knob to position 4. The thermostat can be adjusted sleeplessly between positions 1 and MAX, Then set it to the desired temperature by trial and error. The higher the setting of the thermostat, the colder the freezer. Each time you change the thermostat setting, fet the freezer run for 24 hours so that the temperature inside it and that of the food packages will have time to adapt to the new setting.
lce cubes The freezer is equipped with ice trays. Some freezers also have a storage bin for ics cubes. Filo the ice tray three-quarters full at most. Remove the frozen ioe cubes by twisting the ice tray slightly. Care and maintenance Defrosting — refrigerator @ a The refrigerator is defrosted automatically every time the compressor stops. The defrost water is carried out via a hose at the rear of the cabinet o a drip tray above the compressor 3 a. This is where the defrost water evaporates.
# (heck that the doors are closed. Do not leave them open finger or open them more often than is absolutely necessary. If it gets too cold » Try with a lower {less cold) thermostat sifting.
Handles on the side of the door Remove the handle. If the handle has a cover for the craws, carefully remove the cover with the hap of a knife inserted from behind the handle. Press plastic plugs into the side of the door whets the hand fitted, using a 4 mm drift. Press the plastic plugs supplied into the holes where the handle used to be fitted. Ventilation Grille Move the blanking piece in the ventilation grille and it the grille back in place.
