EPM09CRC-A1 EPM12CRC-A1 EN AIR CONDITIONER USER MANUAL 2
www.electrolux.com CONTENTS 1. SAFETY INFORMATION ������������������������������������������������������������������������������������� 3 2. SAFETY INSTRUCTION ������������������������������������������������������������������������������������� 8 3. UNIT DESCRIPTION ����������������������������������������������������������������������������������� 11 4. ACCESSORIES INCLUDED ��������������������������������������������������������������������� 11 5.
ENGLISH 1. 3 SAFETY INFORMATION Symbol Note WARNING CAUTION CAUTION CAUTION Explanation This symbol shows that this appliance uses a flammable refrigerant. If the refrigerant is leaked and exposed to an external ignition source, there is a risk of fire. This symbol shows that the operation manual should be read carefully. This symbol shows that a service personnel should be handling this equipment with reference to the installation manual.
www.electrolux.com • There are local council rules regarding maximum allowable noise levels emitted by air conditioners. • If the power cord is to be replaced, replacement work shall be performed by authorised personnel only. • Installation work must be performed in accordance with the national wiring standards by authorised personnel only(if applicable). Incorrect connection can cause overheating and fire. • Take care not to catch fingers on fan when adjusting horizontal louvres.
ENGLISH • In the event of any abnormality with the air conditioner (eg. a burning smell), do not pull out the plug directly, open the window for ventilation firstly, then turn the unit off and disconnect the power supply. CAUTION! Warning - Power cord • This power plug must only be plugged into an appropriate wall socket. Do not use in conjunction with any extension cords. • Push the power plug securely into the socket and make sure it is not loose.
www.electrolux.com 1.3 Usage cautions • Be sure to turn the unit off and disconnect the power supply cord before performing any maintenance or cleaning. • Do not put unit near any heat source or open fire when you replacing the filters. • Do not splash or pour water directly onto the unit. Water can cause electrical shock or equipment damage. • Drainage should be performed whenever moving the air conditioner. If any water remains in the tank, it may spill out while being moved.
ENGLISH 7 PLEASE NOTE: CHECK THE PLATE FOR THE TYPE OF REFRIGERANT GAS USED IN YOUR APPLIANCE. WARNING! Specific information regarding appliances with R290 refrigerant gas. • Thoroughly read all of the warnings. • When defrosting and cleaning the appliance, do not use any tools other than those recommended by the manufacturer. • The appliance must be placed in an area without any continuous sources of ignition (for example: open flames, gas or electrical appliances in operation).
www.electrolux.com 2. SAFETY INSTRUCTION 2.1 Notes on Operation • Allow 4 minutes for the compressor to restart cooling. If you turn the air conditioner off and immediately restart it, allow 4 minutes for the compressor to restart cooling. There is an electronic device in the unit that keeps the compressor turned off for 4 minutes for safety. • In the event of a power failure during use, allow 4 minutes before restarting the unit. After power is reinstated, restart the air conditioner.
ENGLISH 9 warning meaning Plug in power plug properly Otherwise, it may cause electric shock, fire and explosion due to excess heat generation Do not operate or stop the unit by inserting or pulling out the power plug It may cause electric shock, fire and explosion due to heat generation Do not use a damaged or unspecified power cord It may cause electric shock, fire and explosion.
www.electrolux.com CAUTION! caution meaning When the air filter is to be removed, do not touch the metal parts of the unit It may cause an injury Do not clean the air conditioner with water Water may enter the unit and degrade the insulation. It may cause an electric shock Ventilate the room well when used together with a stove, etc.
ENGLISH 11 3. UNIT DESCRIPTION 4 5 3 2 6 1 7 8 9 13 1 Remote control 12 11 10 3 Room air outlet 7 Continuous drain outlet 8 Pump drain outlet 9 Bottom drain outlet 4 Control panel 10 Air exhaust 5 Carrying handle(both sides) 11 Power plug socket 12 Power cord 2 Signal receiver 6 Air intake 13 Castor 4.
www.electrolux.com 5. INSTALLATION INSTRUCTIONS 5.1 Exhausting hot air In the Cool Mode the appliance must be placed close to a window or opening so that the warm exhaust air can be ducted outside. First position unit on a flat floor and make sure there’s a minimum of 50cm clearance around the unit, and is within the vicinity of a single circuit outlet power source. 1. Extend either side of the hose(Fig.1) and screw the hose to adaptor A (Fig.2). 4.
ENGLISH 13 5.2 Installation in a double-hung sash window 1. Cut the Foam seal* (adhesive type) to the proper lengths and attach them to the window and stool. (Fig. 8) )RDP VHDO $ DGKHVLYH W\SH 5. Secure the window slider kit to the window sill (Fig. 11): A: For wooden window: Use 19mm screws for securing. B: For Vinyl-Clad windows: Use 12.7 hex head cap screws for securing. PP VFUHZV )LJ 2. Open the window sash and place the window slider kit on the window stool (Fig. 9).
www.electrolux.com 5.3 Installation in a sliding sash window 1. Cut the Foam seal* (adhesive type) to the proper lengths and attach them to the window frame. See Fig. 14. 5. Drive two 19mm screws to secure the window slider kit to the window frame. (Fig. 16) :LQGRZ VWRRO :LQGRZ VOLGHU NLW )RDP VHDO $ DGKHVLYH W\SH )LJ 2. Open the window sash and place the window slider kit on the window stool (Fig. 15). Attach the window slider kit to the window frame.
ENGLISH 15 6. AIR CONDITIONER FEATURES 6.1 Control Panel 1 9 8 7 6 5 1 Displays temperature/time 2 Power ON/OFF 3 Filter Reset 4 Fan Speed 4 3 2 6 Mode Selection* 7 Sleep 8 Timer 9 Swing 5 Adjust Temperature or Timer * Heat mode is not applicable to all models. 7. OPERATING INSTRUCTIONS Some of the following instructions can only be used by using the Control Panel. 7.1 Usage of the Control Panel Before operating the unit, plug in the unit and press the "ON/OFF" button to start.
www.electrolux.com Fan mode In this mode, there is no need to use the exhaust hose or drainage hose. 1. Press the "mode" button until the Fan mode indicator is lit. 2. Press the "Fan speed" button to choose the desired fan speed. 3. The fan will run at the selected speed and the display will show the room temperature. Note: In this mode, auto speed cannot be selected. Auto mode Always have the exhaust hose attached in this mode.
ENGLISH 7.2 Remote Control 17 To replace the old batteries(which have been used up) with two new R03P “AAA” 1.5V batteries, repeat the steps above. 5 6 7 8 1 Remote Control screen 2 Temp/Timer setting button 3 Mode button 4 Timer button 5 On/Off button 6 Speed button 7 Sleep button 8 Swing button * Heat mode is not applicable to all models Battery Installation and Important Instructions Remove the cover at the back of the remote control.
www.electrolux.com How to Use the Remote Control Fan mode Turning the unit on Press the “mode” button until the left side of LCD screen displays “fan”. In this mode, you can select fan speed “high”, “mid” or “low” by pressing the Fan speed button and referring to the diagram. Note: In this mode, the air exhaust hose does not need to be connected. Plug in the unit, then press the “on/ off” button (when turned on, the unit will operate as the last setting before shutdown.
ENGLISH 19 Sleep mode When the unit is in Cool, Heat or auto mode, you can press the “sleep” button to make the unit run in Sleep mode. In this mode, the fan speed will be set as “auto” automatically, which cannot be changed. In Cool/Heat mode the selected temperature will increase/decrease by 1 °C 30 minutes after the mode is selected. The temperature will then increase/decrease by another 1 °C after an additional 30 minutes.
www.electrolux.com How to delay shutdown (Timer off) You can delay shutdown when the unit is on. Press the “timer” button, the screen will display “timer”and “h”, and the “off” will flashing. Tap or hold the UP "+" or DOWN "-" button to change delay stop timer at 0.5 hour increments up to 10 hours, then at 1 hour increments up to 24 hours. After 3 seconds, the setting will be memorized, and the display will show the time remaining until the unit shuts down.
ENGLISH Fig. 22 21 Replace the drain cap to the continuous drain outlet when no condensate flows out. Put the drip tray under the bottom drain outlet, then remove the rubber stopper from the drain outlet, to allow the condensate to flow into the drip tray. If your drip tray can’t hold all the condensate, a number of fills will be needed. Replace the drain cap to the bottom drain outlet when no condensate flows out. Bottom Drain Outlet Fig.
www.electrolux.com 2. Wash the filter using liquid dishwashing detergent and warm water under 40°C. Rinse filter thoroughly. Gently shake excess water from the filter. Be sure filter is thoroughly dry before replacing. Or, instead of washing you may vacuum the filter clean. 3. Replace the filter after the filter is dry. Be sure filter is thoroughly dry before replacing. 8.3 Winter Storage If the air conditioner will not be used for an extended period of time: 1.
ENGLISH • Exhaust duct not connected or blocked. See "5.1 Exhausting hot air" Section. Air conditioner cooling, but room is too warm - ice forming on cooling coil behind decorative front • Dirty air filter - air restricted. Clean air filter. Refer to "8. Care and Cleaning" section. • Temperature is set too high. Set temperature to a lower setting. • Air directional louvres positioned improperly. Position louvres for better air distribution. • Front of unit is blocked by drapes, blinds, furniture, etc.
www.electrolux.com ELECTROLUX PORTABLE AIR CONDITIONER Electrolux Electrolux 24 24 Repair or replace warranty: During the Warranty Period, return to service centre, Electrolux or its ASC will, at no extra charge if your Appliance is readily accessible for service, without special equipment and subject to these terms and conditions, repair or replace any parts which it considers to be defective.
Andes_ANZ_June_01 www.electrolux.
