Electric Hobs INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance EPEH 35674-9001 GB
Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950 Installation l l l l This hob must be installed by qualified personnel, according to the manufacturers instructions and to the relevant British Standards. Remove all packaging before using the hob. Ensure that the electrical supply complies with the type stated on the rating plate, located on the bottom of the hob.
Contents For the Installer For the User Important Safety Information 2 Installation 11 Description of the Hob 3 Building In 11 Operation 4 Electrical connections 13 Hints and Tips 4 Wiring diagram 14 Maintenance and Cleaning 5 Something Not Working? 6 Service and Spare Parts 6 Guarantee Conditions 7 Description of the Hob 3 1 2 5 4 7 1. 2. 3. 4. 5. 6. 7. 6 Hob Top Rapid Hotplate - 2090 W/180 mm dia. Normal Hotplate- 1040 W/145 mm dia. Rapid Hotplate - 1570 W/145 mm dia.
Operation Electric Hotplates To switch on a hotplate, turn the relevant control knob anticlockwise to the required heat setting. Suggestions for the correct setting of the plates are given in the following table. The control knob is numbered 1 - 6 0 - OFF 1 - Minimum 6 - Maximum. The hob has two types of hotplates: Normal Hotplates We recommend the plates are switched to maximum (6) for a short while to boost the plate, and then adjusted to the required setting.
Take care never to lean or reach over a hot electric plate. Always point pan handles inward or over the work surface next to the hob to avoid accidentally knocking over a pan as you pass by. Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. If the control knobs become difficult to turn, please contact your local Electrolux Service Centre.
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM SOLUTION n The plate does not heat up. u Check that the unit is plugged in and the electrical supply is switched on u Check that the RCCB has not tripped (if fitted) u Check the mains fuse has not blown u Check the correct control knob has been turned.
Guarantee Conditions Electrolux Standard Guarantee Conditions We, Electrolux, undertake that if, within 12 months of the date of the purchase, this Electrolux appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or materials, we will, at our option, repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: * The appliance has been correctly installed and used only on the gas and electricity supply stated on the rating plate
ELECTROLUX SERVICE FORCE To contact your local Electrolux Service Force Centre telephone 08705 929 929 CHANNEL ISLANDS GUERNSEY Guernsey Electricity PO Box 4 Vale, Guernsey Channel Islands JERSEY Jersey Electricity Company PO Box 45 Queens Road St Helier Jersey Channel Islands JE4 8NY SCOTLAND ABERDEEN (M05) 54 Claremont Street Aberdeen AB10 6RA AUCHTERMUCHY (M03) 33A Burnside Auchtermuchy Fife KY14 7AJ BLANTYRE (M07) Unit 5 Block 2 Auchenraith Industrial Estate Rosendale Way Blantyre G72 0NJ DUMF
ELECTROLUX SERVICE FORCE To contact your local Electrolux Service Force Centre telephone 08705 929 929 MIDLANDS BIRMINGHAM (M18) BOURNE (M44) BRIDGNORTH (M72) 66 Birch Road East, Wyrley Road Industrial Estate Witton Birmingham B67DB Manning Road Ind Estate Pinfold Road Bourne PE10 9HT 65 St.
Instructions for the Installer Engineers technical data Heating elements Ratings Rapid front left Hotplate Ø 180 mm Normal back left Hotplate Ø 145 mm Rapid front right Hotplate Ø 145 mm Normal back right Hotplate Ø 180 mm Total rating Overall dimensions 2090 W 1040 W 1570 W 1570 W 6270 W Width: Depth: Height: 580 mm. 500 mm. 8 mm. Cut out dimensions Width: Depth: Thickness: 550 mm. 470 mm. 30 mm.
Installation The hob must be installed according to the instructions supplied. The hob must be installed by qualified personnel to the relevant British Standards. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. WHEN THE HOB IS FIRST INSTALLED Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory.
Building over a kitchen unit with door 20 min Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be hot when in operation. The recommended solution is shown in diagram 3. The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections. 30 3 a 60 b FO 1013 Dimensions are given in mm.
Electrical connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. The hob should be connected to a double pole switch with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations.
Wiring diagram N Ø 145 Ø 180 Ø 145 Ø 180 4 3 2 1 4 3 2 1 4 3 2 1 4 3 2 1 1 2 3 4 P2 4 3 P1 1 2 P3 5 P2 4 3 P1 1 2 P3 5 P2 4 3 P1 1 2 P3 5 P2 4 3 P1 1 2 P3 5 PLATE L 14
55-77 High Street Slough Berkshire, SL1 1DZ Tel: 08705-950950 © Electrolux Household Appliances Limited 2000 Grafihe MDM - Forlì CUSTOMER CARE
