User manual

8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
Installing the door and the glass
panels
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite se-
quence. Install the smaller panel first, then
the larger.
12. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does not
heat up.
The appliance is deacti-
vated.
Activate the appliance.
The appliance does not
heat up.
The time of day is not set. Set the clock. Refer to
"Setting and changing the
time”.
The appliance does not
heat up.
The necessary settings
are not set.
Make sure that the set-
tings are correct.
The appliance does not
heat up.
The automatic switch-off
is activated.
Refer to „Automatic
switch-off“.
The appliance does not
heat up.
The fuse is released. Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact
a qualified electrician.
The lamp does not oper-
ate.
The lamp is defective. Replace the lamp.
The display shows C1. You want to start the py-
rolytic cleaning but you
did not remove the shelf
support/telescopic run-
ners.
Remove the shelf sup-
port/telescopic runners.
The display shows C2. You want to start the py-
rolytic cleaning, keep
warm or defrost function
but you did not remove
core temperature sensor
plug from the socket.
Remove the core temper-
ature sensor plug from
the socket.
30
www.electrolux.com