User manual

The gas rate is adjusted to suit.
WARNING!
Before you replace the
injectors, make sure that the
gas knobs are in the off
position. Disconnect the
oven from the mains. Wait
until the oven is cold. There
is a risk of injury.
3.3 Gas grill injector
replacement
1. Release the screws which keep the
grill burner in position (A).
A
2. Carefully move forward the burner off
the injector support. Slowly move it
down. Do not apply force to the wire
of the spark plug connector (B) and
to the thermocouple conductor (C).
3. Release the burner injector (D) with a
7 mm socket spanner and replace it
with a different one which is
necessary for the type of gas you use.
Refer to “Technical data” chapter.
D
C
B
4. Assemble the burner in a reverse
sequence. Before you fix the screw,
make sure that the burner is pushed
correctly to the back panel.
Test the grill injectors.
3.4 Oven injector replacement
1. Remove the bottom plate of the
oven cavity (A) to get access to the
oven burner (B).
AB
2. Release the screw (C), which keeps
the burner in position.
C
3. Carefully move the burner off the
injector support (D).
D
E
F
4. Slowly move it to the left side. Do not
apply force to the wire of the spark
plug connector (F) and to the
thermocouple conductor (E).
5. Release the burner injector (D) with a
7 mm socket spanner and replace it
with a different one, which is
necessary for the type of gas you use.
www.aeg.com
8