BGB101011M USER MANUAL EN User Manual Oven
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. INSTALLATION............................................................................................................7 4. PRODUCT DESCRIPTION.........................................................................................11 5.
ENGLISH 3 manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • • Before carrying out any maintenance, disconnect the appliance from the power supply. WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. Do not use the appliance before installing it in the built-in structure. Do not use a steam cleaner to clean the appliance.
ENGLISH Width of the front of the appliance 595 mm Width of the back of the appliance 559 mm Depth of the appliance 569 mm Built in depth of the appliance 548 mm Depth with open door 1022 mm Ventilation opening minimum size. Opening placed on the bottom rear side 560x20 mm Mains supply cable length. Cable is placed in the right corner of the back side 1500 mm Mounting screws 4x25 mm • • • • • • 2.2 Electrical connection WARNING! Risk of fire and electric shock.
www.aeg.com • Make sure that there is air circulation around the appliance. • The information about the gas supply is on the rating plate. • This appliance is not connected to a device, which evacuates the products of combustion. Make sure to connect the appliance according to current installation regulations. Follow the requirements for adequate ventilation. 2.4 Use WARNING! Risk of injury, burns and electric shock or explosion. • This appliance is for household use only.
ENGLISH abrasive cleaning pads, solvents or metal objects. • If you use an oven spray, follow the safety instruction on it's packaging. • Do not clean the catalytic enamel (if applicable) with any kind of detergent. 2.6 Internal lighting WARNING! Risk of electric shock. • The type of light bulb or halogen lamp used for this appliance is for household appliances only. Do not use it for house lighting. • Before replacing the lamp, disconnect the appliance from the power supply.
www.aeg.com The gas rate is adjusted to suit. B A WARNING! Before you replace the injectors, make sure that the gas knobs are in the off position. Disconnect the oven from the mains. Wait until the oven is cold. There is a risk of injury. 3.3 Gas grill injector replacement 1. Release the screws which keep the grill burner in position (A). 2. Release the screw (C), which keeps the burner in position. A C 2. Carefully move forward the burner off the injector support. Slowly move it down.
ENGLISH Refer to “Technical data” chapter. 6. Assemble the burner in a reverse sequence. Replace the gas type sticker near the gas supply ramp with the one related to the new gas type. The gas oven burner does not need any primary gas regulation. Make sure that the gas supply pressure of the appliance is in line with the recommended values. If the supply gas pressure is changeable or different than the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. 3.
www.aeg.com min. 4mm 548 80 21 min. 550 60 520 110 114 18 600 min. 560 589 594 65cm² 130cm² 595±1 198 60 5 3 523 20 50 548 70 21 min. 550 60 520 110 590 114 18 110 min. 560 589 594 60 595±1 5 3 20 198 65cm² 130cm² 523 There must be a clearance of minimum 4 mm between the top surface of the appliance and the inner top of the cabinet. When you install the appliance "builtunder" (below a hob), install the hob before the oven unit.
ENGLISH For correct operation, the oven cabinet must have a minimum opening of 130 cm² in the front or on the sides (a minimum of 65 cm² for each side). The manufacturer recommends a 130 cm² opening in the front for a brick cabinet and a 65 cm² opening for each side for a wooden cabinet. 11 3.7 Securing the oven to the cabinet When you install a hob above the oven, make different electrical connections for the hob and for the oven. Only make connections with correct cables for the power supplied.
www.aeg.com accessories. Before you use the oven for the first time, put the bottom plate with the hole on its front part in the burner area, as shown in "Product description" chapter. 5.2 Initial Cleaning Remove all accessories and removable shelf supports from the oven. Refer to "Care and cleaning" chapter. Clean the oven and the accessories before the first use. Put the accessories and the removable shelf supports back to their initial position. 1. Set the maximum temperature. 2.
ENGLISH Symbol 13 Function Heats from the top. Grill 6.4 Oven functions Oven function Application The oven is off. Off position To turn on the lamp without a cooking function. Light To roast larger pieces of meat on the turnspit. Turnspit 6.5 Using the grill Oven safety device: The gas oven has a thermocouple. It stops the gas flow if the flame goes out. 1. Press the knob for the gas control and turn it to . Keep the knob for the gas control pushed for 15 seconds or less.
www.aeg.com 8.1 Using the turnspit WARNING! Be careful when you use the turnspit. The forks and the spit are sharp. There is a risk of injury. WARNING! Use oven gloves when you remove the turnspit. The turnspit and the grill are hot. There is a risk of burns. A B C D A. B. C. D. Turnspit frame Forks Spit Handle 1. Put the turnspit handle into the spit. 2. Put the deep pan on the lowest shelf position. 3. Put the spit frame on the third shelf position from the bottom. 4.
ENGLISH 15 Wire shelf and baking tray together: Push the baking tray between the guide bars of the shelf support and the wire shelf on the guide bars above. Small indentation at the top increase safety. The indentations are also anti-tip devices. The high rim around the shelf prevents cookware from slipping of the shelf. 9. ADDITIONAL FUNCTIONS 9.1 Cooling fan When the oven operates, the cooling fan turns on automatically to keep the surfaces of the oven cool.
www.aeg.com condensation, add water each time after it dries up. Pizza Preheat the empty oven before cooking. Cooking times Cooking times depend on the type of food, its consistency, and volume. Prepare 1.4 - 1.5 kg of food. Initially, monitor the performance when you cook. Find the best settings (heat setting, cooking time, etc.) for your cookware, recipes and quantities when you use this appliance. 10.2 Cooking tables Casserolesl Preheat the empty oven before cooking. Prepare 1.5 - 2.
ENGLISH 17 Use the wire shelf. Put a deep pan on the second shelf position. Food Temperature (°C) Time (min) Vol-au-vent 170 25 - 35 Jam tart in a 30 cm round cake mould on the wire shelf 165 50 - 60 Use the third shelf position. Food Temperature (°C) Time (min) Bone-in beef, 1.0 kg min. 50 - 65 Boneless beef, 1.0 kg 190 55 - 65 Pudding Preheat the empty oven for 10 minutes before cooking. Lamb, 1.0 kg min. 50 - 65 Use 9 ceramic ramekins. Chicken / Rabbit, 1.
www.aeg.com Use the aluminium baking tray. Food Use the fourth shelf position. Food Temperature (°C) Time (min) Pieces Time (min) 1st side 2nd side Bread loaves, 0.5 180 - 190 kg 50 - 60 Chicken breast, 0.4 kg Bread loaves, 1.0 180 - 190 kg 60 - 70 Fish fillet, 0.4 kg 4 13 - 15 12 - 14 Rolls and buns 25 - 35 Toasted sandwiches 4-6 5-7 - Toast 4-6 2-4 2-3 180 - 190 10.4 Grilling Preheat the empty oven for 3 minutes before cooking. Use the fourth shelf position.
ENGLISH (°C) (min) 19 Sponge cake, cake mould Ø26 cm Conventional Cooking Wire shelf 4 170 50 - 60 Preheat the oven for 10 minutes. Short bread Conventional Cooking Aluminized baking tray 4 160 170 25 - 40 Preheat the oven for 10 minutes. Toast, 4 6 pieces Grill Wire shelf 4 max. 2 - 3 minutes first side; 2 - 3 minutes second side Preheat the oven for 3 minutes. Beef burger, 6 pieces, 0.6 kg Grill Wire shelf and dripping pan 4 max.
www.aeg.com Clean all accessories after each use and let them dry. Use a soft cloth with warm water and a cleaning agent. Do not clean the accessories in a dishwasher. Accessories Do not clean the non-stick accessories using aggressive agents, sharpedged objects or in a dishwasher. 11.2 Stainless steel or aluminium ovens Clean the oven door with a damp cloth or sponge only. Dry it with a soft cloth. Do not use steel wool, acids or abrasive materials as they can damage the oven surface.
ENGLISH 2. Lift and turn the levers fully on both hinges. 3. Close the oven door halfway to the first opening position. Then lift and pull forward and remove the door from its seat. 21 7. Hold the door glass panel by its top edge and carefully pull it out. Make sure the glass slides out of the supports completely. 8. Clean the glass panels with water and soap. Dry the glass panels carefully. Do not clean the glass panels in the dishwasher.
www.aeg.com The back lamp 1. Turn the lamp glass cover to remove it. 2. Clean the glass cover. 3. Replace the lamp with a suitable 300 °C heat-resistant lamp. 4. Install the glass cover. 12. TROUBLESHOOTING WARNING! Refer to Safety chapters. 12.1 What to do if... Problem Possible cause Remedy The oven does not heat up. The oven is off. Turn on the oven. The oven does not heat up. The fuse is blown. Make sure that the fuse is the cause of the malfunction.
ENGLISH 12.2 Service data If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. 23 on the front frame of the oven cavity. Do not remove the rating plate from the oven cavity. The necessary data for the service centre is on the rating plate. The rating plate is We recommend that you write the data here: Model (MOD.) ......................................... Product number (PNC) ......................................... Serial number (S.N.) ......
www.aeg.com 13.3 Gas grill burner Gas type NOMINAL GAS POWER (kW) NOMINAL Reduced GAS FLOW gas power (g/h) (kW) BY-PASS INJECTOR NEEDLE MARK (1/100 mm) (1/100 mm) G20 (2H) 20 mbar 1.85 - - - 92 G30 (3+) 28-30 mbar 2.0 145 - 43 71 G31 (3+) 37 mbar 2.0 145 - 43 71 14. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it.
ENGLISH 25
www.aeg.
ENGLISH 27
867355284-C-212019 www.aeg.
