User manual

CAUTION!
Chemical de-scaling agents
can cause damage to the
enamel. Follow the
instructions of the
manufacturer.
1. To clean the water drawer and the
steam generator, put the water and
vinegar mixture (approximately 250
ml) through the water drawer into the
steam generator. Wait for
approximately 10 minutes.
2. Remove the water and vinegar with
the sponge.
3. Put clean water (100 - 200 ml) into
the water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it
dry.
5. Keep the door open to let the
appliance dry fully.
12.9 Steam generation system
- Rinsing
Remove all accessories.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the function is around 30
minutes.
The light in this function is off.
1. Put the baking tray on the first shelf
position.
2. Press
.
3. Fill the water drawer with fresh water
to the maximum level until the
acoustic signal sounds or the display
shows the message.
4. Press
.
Remove the baking tray after the end of
the procedure.
12.10 Tank Emptying
Remove all accessories.
The cleaning function removes the
residual water from the water drawer.
Use the function after the steam cooking
function.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the function is around 6
minutes.
The light in this function is off.
1. Put the baking tray on the first shelf
position.
2. Press
.
Remove the baking tray after the end of
the procedure.
12.11 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
www.electrolux.com50