user manual Fridge-Freezer END42405X
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2.
electrolux • Connect to potable water supply only.3) Service • Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials.
electrolux 5 First use Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Important! Do not use detergents or abrasive powders, as these will damage the finish. Daily use Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
electrolux There is a grille (if foreseen) on the bottom of the drawer to separate the fruit and vegetables from any humidity that may form on the bottom surface. All parts inside the drawer can be removed for cleaning purposes To regulate the humidity in the vegetable drawer there is a device with slits (adjustable by means of a sliding lever). When the ventilation slots are closed: the natural moisture content of the food in the fruit and vegetable compartments is preserved for longer.
electrolux 7 the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption.
electrolux 2 Water lever 6 3 Water drop tray 3 Initial operations to use your water dispenser 1. Remove every tape and other protection system from the tank assembly 2. clean the components, as described into "Water dispenser cleaning procedure", in order to remove eventual residue. 5 2 Water dispenser cleaning procedure 1.
electrolux 9 8. Put the assembled tank on the door along the valve direction. 9. Block the stopping elements in the inverse order of unblock. 10. Insert again the BRITA MAXTRA cartridge in the funnel . A 4. Unscrew the valve in counter clockwise (pay particular attention not to lose the Valve Gasket because is necessary to a correct functioning of the features ). 5. Clean the tank lid, the valve and the gasket with a solution of warm water and neutral soap.
electrolux pour it inside the tank through the cover as shown into the picture (use the lid every time that you want to fill your water). Important! In order to avoid risk of spillage of water during closing and opening of the refrigerator door, we recommend to not fill completely the water tank but leave a head space of air (max. refilling limit till the frontal marks).
electrolux 11 mends that you replace the cartridge in the BRITA unit of your fridge every four weeks. BRITA Memo automatically reminds you when to change the cartridge. START START % 100 75 50 25 % 100 75 50 25 Functional control The flashing dot in the bottom right corner of the Memo indicates that the Memo is working. The unique BRITA Memo measures the recommended time of use of your cartridge. Memo is easy to use and automatically reminds your when to change your cartridge.
electrolux Every week one bar will disappear to show the remaining cartridge life. After four weeks all four bars will disappear. This, and a flashing arrow, indicate that the cartridge should now be changed. Insert a new cartridge according to the instructions and reactivate the Memo as described above. START % 100 75 50 25 Change display START START % 100 75 50 25 When only one bar is showing, you should just check whether you have a new BRITA MAXTRA filter cartridge to hand.
electrolux 13 Important information • The fridge door valve hole must be closed with the Water Valve during the regular functioning of the appliance. • Use only drinking water. The use of any other drink type can leave residues, taste or odor in the reservoir and in the tap. • It is possible to hear some noises caused by air entering when the water left the reservoir. • In case the water does not flow well, press the driving lever once again.
electrolux Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates.
electrolux 15 Problem Possible cause Solution The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The temperature is not set correctly. Set a higher temperature. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The product temperature is too high. Let the product temperature decrease to room temperature before storage.
electrolux 5. Tighten the screw to the lamp cover. 6. Connect the plug to the mains socket. 7. Open the door. Make sure that the light comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center.
A B 10 mm 10 mm 100 mm electrolux 17 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician.
electrolux 2. Remove the upper door. 3. Remove the upper support and mount it in the opposite side. 4. Unscrew the middle hinge (H). Unscrew the plastic plugs located on the opposite side of the central hinge and introduce them in the holes occupied before by the hinge. H 7. Carefully place the appliance on its back, totally unscrew the adjustable foot and screw it in the opposite side. 8. Remove the bottom hinge by unscrewing its fixing screws. 9.
electrolux 19 13. Refit the ventilation grille, fixing the screws. 14. Reassemble the lower door. 15. Reassemble the middle hinge (H) in the opposite side. 16. Reassemble the upper door. 17. In your documentation bag you will find the upper hinge necessary to make the reversibility. Please screw it in place. Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e.
www.electrolux.
