Technical data

wh Münzprüfer Dietmar Trenner GmbH, Germany Technical Manual EMP 8x0.00/04/13 v5
Version 1.51
EMP8x0.00/04/13 v5 subject to technical modification page 39/42
Figure 14 Example of an EMP 800 v5 Label
At the top is printed the exact type of coin selector. In this example:
EMP 800.00 v5
At the end of the same line you find the installed options. In this example:
/X Control for external sorting flaps
On the left, besides the barcode (turned 90°) is the serial number and the week
and year of manufacture. The same information is contained in the bar code. On
the very left is the number of the technical specification, that has been used when
programming the device in the factory.
The remaining space on the label is devoted to the specification of the
programmed coins. These specifications are in the form of a table. The columns
have the following meaning:
Coin type (Value and currency)
Teach mode channels are marked with TKn. „n“ = number of blocking
switch, which has to be used to activate the teach mode for this
channel
Blocking switch for the broad channel
Blocking switch for the narrow channel
Blocking switch for the very narrow channel
Blocking switch for a coin type or coin group (currency)
Output line