Technical data

Technical Manual EMP 8x0.00/04/13 v5 wh Münzprüfer Dietmar Trenner GmbH, Germany
Version 1.51
Page 38/42 subject to technical modification EMP8x0.00/04/13 v5
$9E General blocking 2 Coin blocked
$9F EMP busy 13 Not ready
3.4.3 cctalk adjustments using wheasy 3
Using wheasy 3 all cctalk settings can be carried out under “configuration” –
“cctalk”.
Figure 13 shows the window with the cctalk adjustments. Coin ID according to
cctalk specifications as well as initial address of coin selector can be set here. For
most currencies these IDs can be taken out of the indications given under “Coin
value” and “status and identify”” (generate switch)
Figure 13 cctalk settings
In some special cases it is necessary to have a configuration that differs from the
specifications. For example all coins should be released during power on and “500
ms Poll Timeout” should be deactivated in case the coin selector is supposed to be
used with cctalk and parallel interface at the same time.
4 The Label
The label of the coin selector has all the necessary information required by the
machine controller such as the output lines and blocking switch configurations. The
following section explains and clarifies the format and legend on the label.