Technical data

Technical Manual EMP 8x0.00/04/13 v5 wh Münzprüfer Dietmar Trenner GmbH, Germany
Version 1.51
Page 10/42 subject to technical modification EMP8x0.00/04/13 v5
1 2 3 4 5 6 7 8
on
1 2 3 4 5 6 7 8
on
EMP 800
controller
power
Figure 2 Connection between a coin operated machine (controller), an installed
coin selector and a PC
! Every coin selector is fully tested and configured at the factory and is
supplied ready for installation. Please store the factory settings on the
hard disk before making changes. The settings could be stored with a
file name incorporating the serial number. The coin selector must be
“read out” first and this procedure is explained in the wheasy 3
manual.
Please also note the information on the coin selector label.
It is important that the coin selector be located in an upright stance
when programming. Similarly, the bottom surface of the coin selector
needs to be horizontal. This can often be achieved by mounting the
coin selector in the same manner that it is mounted in the vending
machine. Alternatively, wh Münzprüfer can provide you with a purpose
designed stand T 800.
The following sections detail each wheasy 3 related function of the coin selector.
Each function has its own chapter as listed in the table of contents in this manual.