Installation Guide

4
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Important Notes to the Installer
1. Readallinstructionscontainedintheseinstallation
instructionsbeforeinstallingthecooktop.
2. Removeallpackingmaterialbeforeconnectingthe
electricalsupplytothecooktop.
3. Observeallgoverningcodesandordinances.
4. Besuretoleavetheseinstructionswiththeconsumer.
Important Note to the Consumer
KeeptheseinstructionswithyourUseandCareGuidefor
futurereference.
IMPORTANT SAFETY
INSTRUCTIONS
• Be sure your cooktop is installed and grounded
properly by a qualified installer or service
technician.
•These cooktops must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70—latest edition in the United States, or with
CSA Standard C22.1, Canadian Electrical Code,
Part 1, in Canada.
WARNING
The electrical power to the cooktop
must be shut off while line connections are being
made. Failure to do so could result in serious injury
or death.
Provide Electrical Connection
Installthejunctionboxunderthecabinetandrun
120/240or120/208Volt,ACwirefromthemain
circuitpanel.NOTE:DONOTconnectthewiretothe
circuitpanelatthistime.Waituntilallwireshavebeen
connectedinthejunctionbox.
Electrical Requirements
Observe all governing codes and local ordinances.
1. A3-wireor4-wiresinglephase120/240or120/208
Volt,60HzAConlyelectricalsupplyisrequiredona
separatecircuitfusedonbothsidesoftheline(time-
delayfuseorcircuitbreakerisrecommended,40Aor
50A).DONOTfuseneutral.
NOTE:Wiresizesandconnectionsmustconformwith
thefusesizeandratingoftheapplianceinaccordance
withtheNationalElectricalCodeANSI/NFPANo.70–
latestedition,orwithCSAstandardC22.1,Canadian
ElectricalCode,Part1,andlocallocalcodesand
ordinances.
WARNING
An extension cord must not be used
with this appliance. Such use may result in a fire,
electrical shock, or other personal injury.
2. Theapplianceshouldbeconnectedtothefused
disconnect(orcircuitbreaker)boxthroughexible
armoredornonmetallicsheathedcable.Theexible
armoredcableextendingfromthisapplianceshould
beconnecteddirectlytothegroundedjunctionbox.
Thejunctionboxshouldbelocatedasshownin
Figure3withasmuchslackaspossibleremainingin
thecablebetweentheboxandtheappliance,soit
canbemovedifservicingisevernecessary.
3. Asuitablestrainreliefmustbeprovidedtoattach
theexiblearmoredcabletothejunctionbox.
Unpacking Instructions
1. Unpackandvisuallyinspectthecooktop
2. Besurethebottleofcleanerconditionerpacked
intheliteraturebagisleftwheretheusercan
nditeasily.Itisimportantthattheceramic-glass
smoothtopbepretreatedbeforeuseseeCooktop
Cleaning and Maintenance section in the Use and
Care Guide.
Model and Serial Number Location
Theserialplateislocatedunderthecooktop.
Whenorderingpartsforormakinginquiresaboutyour
cooktop,alwaysbesuretoincludethemodelandserial
numbersandalotnumberorletterfromtheserialplate
onyourcooktop.
Figure3