|nstallafion |nstrucfions _, lnstrucciones ,_ ....
iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. if the information exactly, damage, a fire or explosion may personal injury or death. FOR YOUR --- in this manual result iNSTALLER.
ImportantNotesto the Installer 1. Readall instructions contained 2. 3. 4. in these installation instructions before installing range. Remove all packing material from the oven compartments before connecting the gas and electrical supply to the range. Observe all governing codes and ordinances. Be sure to leave these instructions with the consumer. Important Note to the Consumer 1. Keep these instructionswith your Use & Care Manual for future reference.
Before Starting Tools You Will Need For leveling legs and Anti=Tip Bracket: Adjustable wrench or channel lock pliers 5/16" Nutdriver or Flat Head Screw Driver Electric Drill & 1/8" Diameter Drill Bit (5/32" Masonry Drill Bit if installing in concrete) For gas supply connection: Pipe wrench For burner flame adjustment: Phillips head _ and blade-type screwdrivers Additional Materials A. Locate the Bracket Using the Template - (Bracket may be located on either the left or right side of the appliance.
C. Level & Position Appliance- Level appliance by adjusting the (4) leveling legs with a wrench. NOTE: A minimum clearance of 1/8" is required between the bottom of the appliance and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slide appliance back into position. Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip Bracket by removing lower panel or storage drawer.
d) e) t) g) the 1/2" flare union adapter with an adjustable wrench before tightening the gas supply fitting and!or appliance conduit (Refer to Fig. 4e). Install flare union adapter to external manual shut-offvalve. Attach appliance conduit to flare union on shut-off valve. Make sure service shut-off valve on pressure regulator is in the "ON" position (See Fig. 40. Check for leaks.
6.Assembly of the Surface Burner Heads, Burner PLEASEREADCAREFULLY! Forpersonal Caps and Burner Grates: safety,thisproductmustbeproperlygrounded. It is very important to make sure that Grounding instructions The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong grounding wall receptacle to minimize the possibility of electric shock hazard from this appliance.
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. 7. Electric ignition Surface Burners Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. a.
Afterremoving allpacking materials andliterature fromtheoven: a) Setovento BAKEat 300°F.SeeUse & Care Manual for b) c) d) operating instructions. Within 60 seconds the oven burner should ignite. Check for proper flame and allow the burner to cycle once. Reset controls to OFF. If your model is equipped with a waist-high broiler, set oven to BROIL. See Use & Care Manual for operating instructions. Within 60 seconds the broil burner should ignite. Check for proper flame. Reset controls to OFF. 10.
