Manualshelf

Troubleshooting guide

ManualsBrandsElectrolux ManualsDomestic AppliancesEI24WC65GS0
9101112131415161718
i;i!i_i_!ii;i!ii;i!i;:ill¸i¸i!ii!:!iii:!iii:!!!i¸ii_iii!i¸II!I¸_!_i_i;!;!i_ii;i_i_;_i_;_i_ii_i_ii_i_ii_i_i;_ii_;!i_!i_i_!i_i_!i_i_!i_i_!i_i_i!:iii
Troubleshooting
Before You Call fo_" Se_'vice _f Service is Required
_ftheunitappearstobemalfunctioning,read Contactthedea_erwhereyoupurchasedtheunit
through this manual first. If the problem persists, if service is required. State the model and serial
check the Troubleshooting Guide below. Locate number and explain the problem. The model and
the problem in the guide and refer to the cause serial number plate is located on the ceiling of your
and its remedy before calling for service. The unit.
problem may be something very simple that can
be solved without a service call. Some remedies If you do not know the name of the selhng dealer or
listed in the Troubleshooting Guide are very a local serv,ce company, you can check onhne at
:: [ complex. Consulting or contracting a qualified www.electroluxusa.com or call 1-877-435-3287.
:: service technician may be necessary.
Unit not cold enough. ,, Control set too warm. ,, Adjust temperature colder. Allow
..... 24 hours for temperature to
Adjust temperatures (see "Adjusting
the Temperature" in the "Start-Up
and Temperature Control" section).
Unit too cold.
Adjust temperatures (see "Adjusting
the Temperature" in the "Start-Up
and Temperature Control" section).
No interior light.
,, Light staying on.
,, Airflow to front grille blocked.
®
®
stabilize.
Turn off manual light control. See
"Operation" Section.
Airflow must not be obstructed
to front grille. See "installation"
Section.
,, Failed LED assembly. ,, Contact a qualified Electrolux
Service Technician.
Light will not go out when door is ,, Manual light control is ON. ,, Turn off manual light control. See
closed. "Operation" Section.
,, Door switch not making contact. ,, Check for proper door alignment.
,, Door gasket not sealing properly. ,,
,, Control set too cold. ,,
Adjust door gasket.
Adjust temperature warmer.
Allow 24 hours for temperature to
stabilize.