325 88-7670 Rev.
19
Table of contents Contents Page no For the user Safety information ........................................................................................ 4 Description of the product ......................................................................... 5 How to use .................................................................................................... 6 Pilotlight ................................................................................................ 7 Residual-Heat indicator .
Service Safety information These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. Your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. Child Safety Installing Maintenance and Cleaning Do not install the hob if the ceramic glass is damaged or cracked. Only clean this hob in accordance with the instructions given in this book.
Description of the product Technical data Residual-heat indicator Cell Voltage 240 V Electrical connection 240V - 50Hz Total wattage 2900W Instant heat effect 12/18 cm 700/1700 W Instant heat effect 14 cm 1200 W Pilot light This unit is labelled to indicate conformity with the low voltage directive (73/23/EEC) and the EMC directive (89/336/EEC). Control knobs Single plate Unpacking Check that the hob has no faults and is undamaged on delivery.
How to use Control knob (to the left) Control knob for regulating the double plate at the rear Electrical installation Pilot light Control knob for regulating the small plate at the front. 12 2 Regulating 10 4 The regulating of heat is graduation-free for both plates on a scale from 1 to 12. “1” Represents lowest heat “12” Represents maximum heat. “0” Represents “OFF”. 6 8 12 2 10 4 6 8 The electrical connection may only be performed by a qualified electrician/ competent person.
It is not necessary to attach the reinforcement beam to the work top surface, as it is held in place by a specially designed moulding, which is incorporated in the hob units flanges. Pilot light The units externally measured length Residual-Heat indicator Pilot light is activated when either of the zones are turned on, and will remain on until the cooking zones are switched off.
Mounting If you use the advice below you will save energy and make your cleaning tasks easier. Saucepans with very shiny/bright bases will prolong the cooking time slightly compared with cooking utensils with matt/dark bases. Adjust the cooking zones correctly.
The decorative pattern on the ceramic surface can become scratched and marred with use, depending upon maintenance, but does not adversely affect performance. Such blemishes are not covered by the warranty and do not affect the operation of the hob. Spills and melts must be removed immediately, while the surface is still warm, using the scraper supplied with the unit.
Maintenance and cleaning For reasons of hygiene and safety, the cooking zones must be kept clean. Grease stains and spilled food generate smoke when heated, and can even cause fire. Stainless steel surfaces Clean the appliance after use with a soft cloth well wrung out in warm water, use a small amount of liquid detergent for stubborn soiling. Stainless steel parts may become straw coloured with use, use a proprietary stainless steel cleaner to remove this straw discolouration.
