operating instructions Pуководство по эксплуатации Instrucţiuni de utilizare Kullanma ve montaj kýlavuzu RU RO EE LV LT UA TR Gas Hob Варочные панели Plită cu gaz Ankastre ocak EHG 9835
electrolux
electrolux 3 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance.
electrolux Contents For the User Important Safety Information ............................................................................. 5 Operation .......................................................................................................... 7 Using the hob correctly ..................................................................................... 8 Cleaning and Maintenance ................................................................................ 9 Guarantee ..................
electrolux 5 English Important safety information This warnings has been given for the safety of you and others. We therefore ask you to carefully read the procedures of installing and using this cooker. Installation The work of installation must be carried out by competent and qualified installers according to the regulations in force. • Any modifications to the domestic electrical mains which may be necessary for the installation of the appliance should be carried out only by competent personnel.
electrolux • • • • • • appliance. A poor air supply could cause lack of oxygen. Ensure that the gas supply complies with the gas type stated on the identification label, placed near the gas supply pipe. This appliance is not connected to a combustion products evacuation device. It must be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation.
electrolux 7 Operation Hob burner control knobs The symbols on the knobs mean: = no gas supply = maximum gas supply = minimum gas supply For easier lighting, proceed before putting a pan on the pan support. the burners )To Lighting light a burner, turn the relevant knob anticlockwise to maximum position ( ) and push down the knob to ignite. After lighting the flame, keep the knob pushed down for about 5 seconds.
electrolux Using the hob correctly Practical hints The burners To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used. Triple Crown Burner diameter 18-26 cm Rapid Burner diameter 18-26 cm Front Semi-rapid Burner diameter 12-18 cm Rear Semi-rapid Burner diameter 12-22 cm Auxiliary Burner diameter 8-18 cm • For easier lighting, proceed before putting a pan on the pan support. • Use only pans or pots with flat bottom.
electrolux 9 Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. This appliance cannot be cleaned with steam or with a steam cleaning machine. The burners z z z z The burner caps and crowns can be removed for cleaning.
electrolux Hobs with cast iron pan supports: after cleaning, place the pan supports back on their position. In order to carry out this operation correctly, place the central pan support before the side ones. The Hob Top z z z Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little wasing up liquid has been added.
electrolux 11 Technical data Burner gas power (natural gas 20 mbar) Triple crown burner Rapid burner Semi-rapid burner Auxiliary burner 4,0kW 3,0 kW 2,0 kW 1,0 kW Category Gas supply Gas connection Electric supply Appliance class II2H3B/P natural gas G20 (2H) 20 mbar G 1/2" 230 V ~ 50 Hz 3 Hob dimensions Width Depth 894 mm 510 mm Cut out dimensions Width Depth 830 mm 480 mm By-pass diameters Burner Auxiliary Semi-rapid Rapid Triple crown Ø By-pass in 1/100 mm.
electrolux Gas burners NORMAL REDUCED POWER POWER BURNER kW NORMAL POWER NATURAL GAS LPG G20 (2H) - 20 mbar (Butane/Propane) 30 mbar kW g/h inj. 100/mm m3/h inj.
electrolux 13 Installation z z z z The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top.
electrolux IMPORTANT - To ensure a correct operation, a savingof energy and the long life of the appliance, the voltage pressure of the appliance must correspond to the recommended values. The adjustable connection is fixed to the ramp by means of a threaded nut G 1/2". Interpose the sealing between the components as shown in Fig. Screw the parts without forcing, adjust the connection in the required direction and tighten everything.
electrolux 15 Adaptation to different types of gas A. Injectors replacement ) • Remove the pan supports. • Remove the burner's caps and crowns. • With a socket spanner 7 unscrew and remove the injectors (Fig. 1), and replace them with the ones required for the type of gas in use (see table Gas Burners). • Reassemble the parts, following the same procedure backwards. • Replace the rating label (placed near the gas supply pipe) with the relevant one for the new type of gas supply.
electrolux Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force.
electrolux 17 Building In R A SR SR A TC 894 A = Auxiliary burner SR= Semi-rapid burner R = Rapid burner TC= Triple Crown burner 0 51 Fig. 4 Dimensions are given in millimeters These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. 4. The edge of the cut out must have a minimum distance from the rear wall of 55 mm.
electrolux Fitting the hob to the worktop Carry out the building in of the hob as follows: 1. Place the seals supplied with the hob on the front edge of the cut out. Then, place them at 27 mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking care that the seals meet without overlapping. 2. Place the hob in the cut out, taking care that it is centred. 3. Fix the hob with the relevant fixing clamps, supplied with the injectors kit (see diagram).
electrolux 19 Possibilities for insertion Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig. 8. The panel fitted under the hob should be easily removable to allow an easy access if a technical assistance intervention is needed. Kitchen unit with oven The hob recess dimensions must comply the indication given in Fig.
electrolux European guarantee This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law.
