Gas hob - Gazovaà varoqnaà poverxnostì INSTRUCTION BOOKLET RUKOVODSTVO PO éKSPLUATACII Please read this instruction booklet before using the appliance Pohalujsta, proqtite dannoe rukovodstvo pered ispolìzovaniem pribora Mod.
Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. About Installation, Cleaning and Manteinance It is mandatory that all operations required for the installation are carried out by a qualified or competent person, in accordance with existing rules and regulations. Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work.
Contents For the User For the Installer Important Safety Information 2 Technical Data 5 Instruction for the User 3 Instruction for the Installer 6 Maintenance and Cleaning 4 Electrical connection 7 Service and original spare parts 5 Adaptation to different types of gas 8 Building In 9 - This appliance complies with the following E.E.C.
Maintenance and Cleaning Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. The pan supports are dishwasher proof. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. Never use steel wool pads or acids.
Service and original spare parts This machine, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. Original spareparts, certified by the product manufacturer and carrying this symbol are only available at our Service Centre and authorized spareparts shops.
Instruction for the Installer l The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. l The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. l The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top.
Electrical connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force.
Adaptation to different types of gas F Injectors replacement Remove the pan supports. Remove the burner's caps and crowns. With a socket spanner 7 unscrew and remove the injectors (Fig. 5), and replace them with the ones required for the type of gas in use (see Table 2). Reassemble the parts, following the same procedure backwards. Replace the rating label (placed near the gas supply pipe) with the relevant one for the new type of gas supply.
Building In R A SR SR 51 0 UR 680 55 m in. Fig. 7 SR = Semi-rapid burner UR = Triple crown burner 480 A = Auxiliary burner R = Rapid Burner These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. 7. 560 150 min Installation and Assembly FO 2038 Fig. 8 These hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. 8.
Fig. 12 Fig. 11 The hob recess dimensions must comply the indication given in Figs. 12 and 16 and must be provided with brackets to allow a continuous supply of air. To avoid overhating, the building in should be carried out as shown in Figs. 13 and 14. The hob's electric connection and the oven's one must be carried out separately, both for safety reasons and to allow the oven to be easily taken off the unit. Hanging forniture units or hoods must be placed at 650 mm. minimum from the hob (Fig. 16).
