user manual Gas hob CY IE MT GB EHG641
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Installation Product description Operation Helpful hints and tips 2 4 8 8 9 Care and cleaning What to do if… Technical data Environment concerns 10 10 11 12 Subject to change without notice SAFETY INFORMATION Warning! These instructions are only valid in the countries whose symbols appear on this booklet's cover.
electrolux 3 • Use only the accessories supplied with appliance. • Be careful when you connect the appliance to the near sockets. Do not let electricity bonds touch the appliance or hot cookware. Do not let electricity bonds tangle. Installation • You must read these instructions. The manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these requirements.
electrolux with applicable cable. Speak to your local Service Force Centre. • The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. • If the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket.
electrolux 5 components as shown in the diagram. Screw the parts together without using excessive force. 1 2 3 1 End of shaft with nut 2 Washer 3 Elbow Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation.
electrolux Electrical connection • Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. • THIS HOB MUST BE EARTHED. • Always use a correctly installed shockproof socket. • Make sure that there is an access to the mains plug after installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
electrolux 7 Important! The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies, in accordance with the current regulations. sure that the cable section is applicable to the voltage and the working temperature. The yellow/green earth wire must be approximately 2 cm longer than the brown (or black) phase wire. Replacement of the connection cable To replace the connection cable use only H05V2V2-F T90 or equivalent type.
electrolux 50 cm2 120 cm2 360 cm2 180 cm2 MANUFACTURER: ELECTROLUX ITALIA S.p.A. C.
electrolux 9 1 2 3 4 1 2 3 4 Burner cap Burner crown Ignition candle Thermocouple Important! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute.
electrolux CARE AND CLEANING Warning! Switch the appliance off and let it cool down before you clean it. Disconnect the appliance from the electrical supply, before carrying out any cleaning or maintenance work. Warning! For safety reasons, do not clean the appliance with steam cleaners or high-pressure cleaners. Warning! Do not use abrasive cleaners, steel wool pads or acids, they can cause damage to the appliance. • You can remove the pan supports to easily clean the hob.
electrolux 11 Problem Possible cause Remedy The flame is blow out immediately after ignition • Thermocouple is not heated sufficient • After lightning the flame, keep the knob pushed for approximately 5 seconds. The gas ring burns unevenly • Burner crown is blocked with food residues • Make sure that the injector is not blocked and the burner crown is clear of food particles. If there is a fault, first try to find a solution to the problem yourself.
electrolux Hob recess dimensions Category: Width: 560 mm Length: 480 mm Gas connection: Heat input Gas supply: Rapid burner: 3.0 kW Semi-rapid burner: 2.0 kW Auxiliary burner: 1.0 kW TOTAL POWER: G20 (2H) 20 mbar = 8kW G30 (3+) 28-30 mbar = 567 g/h G31 (3+) 37 mbar = 557 g/h Electric supply: II2H3+ (Great Britain, Ireland) I3B/P (Cyprus, Malta) R 1/2" G20 (2H) 20 mbar Appliance class: 3 By-pass diameters Burner Ø By-pass in 1/100 mm.
electrolux 13
electrolux
electrolux 15
www.electrolux.
