user manual Gas hob GB EHG30830K
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Installation Product description Operation Helpful hints and tips 2 4 8 8 9 Care and cleaning What to do if… Technical data Environment concerns 10 10 11 12 Subject to change without notice SAFETY INFORMATION Warning! These instructions are only valid in the countries whose symbols appear on this booklet's cover.
electrolux 3 • Use only the accessories supplied with appliance. • Be careful when you connect the appliance to the near sockets. Do not let electricity bonds touch the appliance or hot cookware. Do not let electricity bonds tangle. • If there is a crack on the surface, disconnect power supply to prevent the electric shock. Installation • You must read these instructions.
electrolux • A qualified electrician must install the clamping connections correctly. • Use a strain relief clamp on cable. • Use the correct mains connection cable and replace the damaged mains cable with applicable cable. Speak to your local Service Force Centre. • The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm.
electrolux 5 On the end of the shaft, which includes the G 1/2" threaded elbow, adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Screw the parts together without using excessive force. 1 2 3 1 End of shaft with nut 2 Washer 3 Elbow Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread).
electrolux Electrical connection • The electrical work necessary to install the appliance must be done by a qualified electrician or competent person, according to the current regulations. • The appliance must be earthed. • Always use a correctly installed shockproof socket. • Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
electrolux 7 Assembly 600 mm min. 650 mm min. 100 mm 40-50 mm 490 mm 55 mm 30 mm 270 mm If several 30 cm hobs are to be installed side by side into the same cut out, an assembly kit including a support side bracket and supplementary seals is available at our Service Centres. The relevant installation instructions are supplied within the kit package.
electrolux 50 cm2 120 cm2 360 cm2 180 cm2 MANUFACTURER: ELECTROLUX ITALIA S.p.A. C.so Lino Zanussi, 30 33080 PORCIA (PN) - ITALIA PRODUCT DESCRIPTION Cooking surface layout 1 1 Triple Crown Burner 2 Control knob 2 Control knobs Symbol Symbol Description Description minimum gas supply no gas supply / off position ignition position / maximum gas supply OPERATION Ignition of the burner Warning! Be very careful when you use open fire in kitchen environment.
electrolux 9 1 2 3 4 1 2 3 4 Burner cap Burner crown Ignition candle Thermocouple Important! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute.
electrolux CARE AND CLEANING Warning! Deactivate the appliance and let it cool down before you clean it. Disconnect the appliance from the electrical supply before you do cleaning or maintenance work. Warning! For safety reasons, do not clean the appliance with steam cleaners or high-pressure cleaners. Warning! Do not use abrasive cleaners, steel wool pads or acids. They can cause damage to the appliance. Scratches or dark stains on the surface have no effect on how the appliance operates.
electrolux 11 Problem The gas ring burns unevenly Possible cause Remedy • Burner crown is blocked with food residues • Make sure that the injector is not blocked and the burner crown is clear of food particles. If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local Service Force Centre.
electrolux TOTAL POWER: G20 (2H) 20 mbar = 3.8 kW G30 (3+) 28-30 mbar = 276 g/h G31 (3+) 37 mbar = 271 g/h Category: II2H3+ Gas supply: G20 (2H) 20 mbar Appliance class: 3 By-pass diameters Electric supply: 230 V ~ 50 Hz 3 core flexible cable Burner Ø By-pass in 1/100 mm. Gas connection: R 1/2" Triple Crown 56 Gas burners BURNER Triple Crown NORMAL POWER REDUCED POWER kW kW 3.8 1.4 NORMAL POWER NATURAL GAS G20 (2H) 20 mbar inj. 1/100 mm m³/h 146 0.
electrolux 13
electrolux
electrolux 15
www.electrolux.
