user manual Gas hob MY SG TH EHG30800
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Installation Product description Operation Helpful hints and tips 2 4 7 7 8 Care and cleaning What to do if… Technical data Environment concerns 9 9 10 11 Subject to change without notice SAFETY INFORMATION Warning! These instructions are only valid in the countries whose symbols appear on this booklet's cover.
electrolux 3 • Use only the accessories supplied with appliance. • Be careful when you connect the appliance to the near sockets. Do not let electricity bonds touch the appliance or hot cookware. Do not let electricity bonds tangle. INSTALLATION • You must read these instructions. The manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these requirements.
electrolux with applicable cable. Speak to your local Service Force Centre. • The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. • If the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket.
electrolux 5 – – – – it is no longer than 1500 mm; it shows no throttles; it is not subject to traction or torsion; it does not get in touch with cutting edges or corners; – it can be easily examined in order to check its condition.
electrolux that the ground connection is in conformity with the standard and regulations force. • The power cable must be placed in such a way that it does not touch any hot part. • Connect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm, eg. automatic line protecting cutout, earth leakage trips or fuse. • None of a parts of the connection cable can not get a temperature 90 °C.
electrolux 7 50 cm2 120 cm2 360 cm2 180 cm2 PRODUCT DESCRIPTION COOKING SURFACE LAYOUT 1 1 Ultra-Rapid Burner 2 Control knob 2 CONTROL KNOBS Symbol Symbol Description Description minimum gas supply no gas supply / off position ignition position / maximum gas supply OPERATION IGNITION OF THE BURNER Warning! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware.
electrolux 1 2 3 4 5 1 2 3 4 Burner cap Burner crown Ignition candle Thermocouple Important! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute.
electrolux 9 CARE AND CLEANING Warning! Deactivate the appliance and let it cool down before you clean it. Disconnect the appliance from the electrical supply before you do cleaning or maintenance work. Warning! For safety reasons, do not clean the appliance with steam cleaners or high-pressure cleaners. Warning! Do not use abrasive cleaners, steel wool pads or acids. They can cause damage to the appliance. Scratches or dark stains on the surface have no effect on how the appliance operates.
electrolux Problem Possible cause Remedy The flame is blow out immediately after ignition • Thermocouple is not heated sufficient • After lightning the flame, keep the knob pushed for approximately 5 seconds. The gas ring burns unevenly • Burner crown is blocked with food residues • Make sure that the injector is not blocked and the burner crown is clear of food particles. If there is a fault, first try to find a solution to the problem yourself.
electrolux 11 Heat input Gas connection: Ultra-Rapid burner: TOTAL POWER: Electric supply: 3.7 kW (Town gas) 4.0 kW (LPG) G 1/2" Category: II1a3B/P Gas supply: G110 (1a) 8 mbar = 3.7 kW G30 (3B/P) 28–30 mbar = 291 g/h G31 (3B/P) 37 mbar = 286 g/h G30/G31 (3B/P) 28– 30/37 mbar Appliance class: 3 By-pass diameters 230 / 240 V ~ 50 / 60 Hz Burner Ø By-pass in 1/100 mm Ultra-Rapid 56 Gas burners BURNER Ultra-Rapid NORMAL POWER REDUCED POWER NORMAL POWER kW kW inj. 1/100 mm m³/h inj.
www.electrolux.
