user manual Gas hob GB EHG30200K
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Installation Product description Operation Helpful hints and tips 2 4 8 8 9 Care and cleaning What to do if… Technical data Environment concerns 9 10 11 12 Subject to change without notice SAFETY INFORMATION Warning! These instructions are only valid in the countries whose symbols appear on this booklet's cover.
electrolux 3 • Use only the accessories supplied with appliance. • Be careful when you connect the appliance to the near sockets. Do not let electricity bonds touch the appliance or hot cookware. Do not let electricity bonds tangle. • If there is a crack on the surface, disconnect power supply to prevent the electric shock. Installation • You must read these instructions.
electrolux • A qualified electrician must install the clamping connections correctly. • Use a strain relief clamp on cable. • Use the correct mains connection cable and replace the damaged mains cable with applicable cable. Speak to your local Service Force Centre. • The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm.
electrolux 5 On the end of the shaft, which includes the G 1/2" threaded elbow, adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Screw the parts together without using excessive force. 1 2 3 1 End of shaft with nut 2 Washer 3 Elbow Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper. The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread).
electrolux Electrical connection • Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. • THIS HOB MUST BE EARTHED. • Always use a correctly installed shockproof socket. • Make sure that there is an access to the mains plug after installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
electrolux 7 R 5mm = 600mm 490+10 mm Possibilities for insertion Kitchen unit with door The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. 30 mm 270+10 mm = a 60 mm min 20 mm (max 150 mm) b A A — supplied seal a) Removable panel b) Space for connections Kitchen unit with oven The hob recess dimensions must obey the indication and the kitchen unit must be equipped with vents to let a continuous supply of air.
electrolux PRODUCT DESCRIPTION Cooking surface layout 1 2 1 Rapid burner 2 Auxiliary burner 3 Control knobs 3 Control knobs Symbol Symbol Description Description minimum gas supply no gas supply / off position ignition position / maximum gas supply OPERATION Ignition of the burner Warning! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame 1 Always light the burner before you put cookware. To light the burner: 1.
electrolux 9 Important! In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. after installation or a power cut. It is normal. Turning the burner off To put the flame out, turn the knob to the .
electrolux ter and dry them carefully before you put them back. • Wash stainless steel parts with water, and then dry them with a soft cloth. • The pan supports are not dishwasher proof. They must be washed by hand. • When you wash the pan supports by hand, take care when you dry them as the enamelling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner. • Make sure you position the pan supports correctly after cleaning.
electrolux 11 If you operated the appliance incorrectly, or the installation was not carried out by a registered engineer, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. 1 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: 2 3 MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY MODEL MOD. PROD.NO. SER.NO.
electrolux By-pass diameters Burner Ø By-pass in 1/100 mm. Auxiliary 28 Burner Ø By-pass in 1/100 mm. Rapid 42 Gas burners NORMAL POWER REDUCED POWER NORMAL POWER NATURAL GAS G20 (2H) 20 mbar LPG (Butane/Propane) G30/ G31 (3+) 28-30/37 mbar BURNER Auxiliary Rapid G30 28–30 mbar G31 37 mba r kW kW inj. 1/100 mm m³/h inj. 1/100 mm g/h g/h 1.0 0.33 70 0.095 50 73 71 2.9 (natural gas) 2.7 (LPG) 0.75 119 0.
electrolux 13
electrolux
electrolux 15
www.electrolux.
