EGG6042 EN HOB USER MANUAL
www.electrolux.com CONTENTS 1. SAFETY INFORMATION............................................................................................ 3 2. SAFETY INSTRUCTIONS.......................................................................................... 4 3. PRODUCT DESCRIPTION.........................................................................................7 4. DAILY USE................................................................................................................ 7 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.electrolux.com • • • • • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance. If the supply cord is damaged, it must be replaced by the manufacturer, an authorized Service or similarly qualified persons in order to avoid a hazard. Where the appliance is directly connected to the power supply, an all-pole isolating switch with a contact gap is required.
ENGLISH • • • • • • • • • • • • • • with the power supply. If not, contact an electrician. Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable or plug (if applicable) can make the terminal become too hot. Use the correct electricity mains cable. Do not let the electricity mains cable tangle. Make sure that a shock protection is installed. Use the strain relief clamp on the cable.
www.electrolux.com temperature than oil used for the first time. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. WARNING! Risk of damage to the appliance. • Do not keep hot cookware on the control panel. • Do not let cookware to boil dry. • Be careful not to let objects or cookware fall on the appliance. The surface can be damaged. • Do not activate the cooking zones with empty cookware or without cookware.
ENGLISH 3. PRODUCT DESCRIPTION 3.1 Cooking surface layout 2 1 1 2 3 4 3 Rapid burner Semi-rapid burner Auxiliary burner Control knobs 4 3.2 Control knob Symbol Symbol Description Description ignition position / maximum gas supply no gas supply / off position minimum gas supply 4. DAILY USE A) B) C) D) WARNING! Refer to Safety chapters. 4.1 Burner overview Burner cap Burner crown Ignition candle Thermocouple 4.2 Ignition of the burner Always light the burner before you put on the cookware.
www.electrolux.com lets the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular. If after some tries the burner does not light, check if the crown and its cap are in correct positions. WARNING! Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute.
ENGLISH CAUTION! Make sure that the pots are placed centrally on the burners in order to get maximum stability and to get lower gas consumption. 5.2 Energy saving Burner Diameter of cookware (mm) Rapid 180 - 260 Semi-rapid 120 - 220 Auxiliary 80 - 180 9 • If it is possible, always put the lids on the cookware. • When the liquid starts to boil, turn down the flame to barely simmer the liquid. 5.3 Diameters of cookware Use cookware with diameters applicable to the size of burners. 6.
www.electrolux.com • Remove when the hob is sufficiently cool: limescale rings, water rings, fat stains, shiny metallic discoloration. Clean the hob with a moist cloth and some detergent. After cleaning, rub the hob dry with a soft cloth. • To clean the enamelled parts, cap and crown, wash them with warm soapy water and dry them carefully before you put them back. Keep these components well clean to prevent difficult lighting and check that the burner crown holes are not obstructed. 6.
ENGLISH 11 7.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C MOD. PROD.NO. SER.NO. 0049 TYPE 230V-50Hz IP20 03 IT MADE IN ITALY A) Stick it on Guarantee Card and send this part (if applicable). B) Stick it on Guarantee Card and keep this part (if applicable). C) Stick it on instruction booklet. 8. INSTALLATION WARNING! Refer to Safety chapters. 8.
www.electrolux.com required even if the volume is between 5 m³ and 11 m³. If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements. For appliances installed in the Republic of Ireland please refer to the NSAI- Domestic Gas Installation I.S. 813 Current Editions Table Four.
ENGLISH 13 8.4 Injectors replacement 8.6 Electrical connection 1. Remove the pan supports. 2. Remove the caps and crowns of the burner. 3. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in "Technical Information" chapter). 4. Assemble the parts, follow the same procedure backwards. 5. Replace the rating plate (it is near the gas supply pipe) with the one for the new type of gas supply.
www.electrolux.com The appliance is supplied with a 3 core flexible power cable with a 3 amp plug. If it is necessary to change the fuse, use a 3 amp ASTA-approved (BS 1362) fuse. A B To replace the connection cable use only H05V2V2-F T90 or equivalent type. Make sure that the cable section is applicable to the voltage load and the working temperature. The yellow/green earth wire (B) must be approximately 2 cm longer than the live and neutral wire (A).
ENGLISH 15 Kitchen unit with door 30 mm A A 60 mm min 20 mm (max 150 mm) B B A) supplied seal B) supplied brackets CAUTION! Install the appliance only on a worktop with flat surface. 8.9 Possibilities for insertion The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary.
www.electrolux.com Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 9.4 Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK 1/100 mm Rapid 3,0 0,75 119 Semi-rapid 2,0 0,45 96 Auxiliary 1,0 0,33 70 9.
ENGLISH 17
www.electrolux.
ENGLISH 19
867305071-GB-072014 www.electrolux.
