User manual
www.electrolux.com 9
UNBOXING & SETUP – picture pages 6-7
Please be careful while unboxing the air purifier. The unit has several detachable
components which may have come loose in transport, so open the box with care and
while placed on a large t surface OR theor.
1. Gently remove the unit (e.g. with top handle when available) and the ancillary
components from the main box. Remove the ppackaging and discard as per
safety and local recycling inns.
2. If wall moung:
a.
b. Ida spot on the wall where you would like to mount the unit. The
spot should be at least 20 cm below eye level when standing fully upright
(even lower is ideal & recommended), for opmal viewing as well as
cleanability under the un
it. Also ensure that nearest power socket is max
1,5 mts away and that there is a clearing of at least 20 cm between right
side (sensor window) of the unit and other nearby surface.
c. Gently place the provided hook t against the surface of the wall and
with a pencil mark the two spots where screws are to be drilled. The hook
should be placed such that the protruding (without the holes) is on
the top (refer to picture #2).
d. Depending on the wall, please use appropriate drill to make two holes
into the wall at the ided marks; and insert any plugs as needed.
e. Depending on the wall, please use appropriate screws for following step.
Place the hook t against the surface of the wall, so that the holes are
concentric and the hook sits p
arallel to the oor without any inclinn,
and then hten the screws the hook is securely in place and does not
move if tugged.
f. L the unit and place it onto the hook such that the top of the hook
securelyinto the inbuilt grip at the back of the unit.
g. Gently adjust the unit to remove any inclinons, just like a paing.
Ensure that the unit sits t up against the wall.
h. When dismoung the unit, remember to disconnect the power cord
from the wall socket.
3. If placing it on the oor:
a. Take the cylindrical feet and screw them into the unit by rotag
clockwise till you hear a click (or get some resistance).
before proceeding. The recommended screw type to use is M5 i.e. of
diameter 5mm (as per hook diameter of 6mm) and of length 40mm.
on which it is to be used.