Gebrauchsanweisung, Libro de Instrucciones EFT 600-2 - EFT 604 Manual de Instruções, User Manual D E P UK
Contents Safety instructions ............................................................................................................. 30 At installation and service ................................................................................................................... 30 At use of cooker hood ......................................................................................................................... 30 At disposal ................................................................
Congratulations to your new Cooker Hood Thank you for your choice of an Electrolux product. We are convinced that you will have great use and pleasure from your new cooker hood. Before you use the cooker hood we recommend that you read through the whole user manual giving a direct description of the cooker hood and its functions.
Description of the appliance 1. Light switch 1 2. Motor speed switch 3. Work light 2 EFT 604 4. Suction grid with grease filter 2 1 Standard accessories included: EFT 600-2 l Screws: l Duct with no return valve l Plug for unused outlet hole 4 Function The hood may be used as follows: - For air exhausting - For air recycling 3 Fig. 1 Exhausting The appliance has two exhaust outlets; D and E (Fig. 2).
Special accessories Active carbon filter When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer PNC 942 120 388 Installation Unpacking Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it.
Mounting of hood on wall l In this case 3 expansion plugs Ø 8 mm and 3 screws 5x45 are needed and must be purchased separate. l Make 3 Ø 8 mm holes in the wall. 2 at points H, 1 as desired at points I. l Insert the three Ø 8 mm expansion plugs into the wall. Fig. 6 l Insert 2 5x45 screws at points H but do not tighten them completely. l Open the grid. l Fit the hood into holes H, tighten the 2 screws. l From inside the hood, insert the third 5x45 screw into hole I (Fig. 6).
Using the hood Speed regulation The hood has a three speed motor regulated with a slide switch. For the best performance, we recommend using the highest speed in particular cases of strong odour and vapour concentration. EFT 604 EFT 600-2 We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. Work light The hood has two lamps 40 W (E 14 candle). Switch on and off with the left slide switch. Fig.
Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Grease filter This serves to hold the grease particles in suspension. The metal filter should be washed every month with warm soapy water or, if possible, in the dishwasher (60°C). Remove the filter: l Open the latch and rotate the grid downwards (Fig. 11). l To remove, pull forward from the right hand side and unhook. l Release the clips B (Fig. 12). Leave to dry before refitting it.
If the hood does not function Before you make contact to service Check that the power plug is connected to the wall power outlet and that no fuse is blown. Do not do any operations that can cause hazard or damage to the product. If the problem remains contact your dealer or an approved service company Remember to save the purchase recite and the Warranty card (only used in some countries) Service and spare parts Service and spare parts you will get via your dealer or service company.
Technical data Model EFT 600-2 / EFT 604 Capacity Max Min.
1007 YW LI1BMA Ed.
