Basic Guide

Changing the bulb for interior lighting
Only use a special bulb which is designed specially
for dryers. The special bulb can be obtained from
your local service centre.
Important! When the appliance is switched on,
the interior lighting switches itself off after 4
minutes when the door is open.
Warning! Do not use standard bulbs! These
develop too much heat and may damage the
machine!
Before replacing the bulb, disconnect the mains
plug; with a permanent connection: fully unscrew
or deactivate the fuse.
1. Unscrew cover above the bulb (this can be
found directly behind the loading aperture, at
the top; refer to “Description of machine” sec-
tion.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket be-
fore screwing back the door light cover. Do not
operate the dryer when missing o-ring gasket on
door light cover.
Warning! For safety reasons, the cover must
be screwed down tightly. If this is not done,
the dryer must not be operated.
Technical specifications
Height x width x depth 85 x 60 x 58 cm
Drum volume 108 l
Depth with loading door open 109 cm
Height can be adjusted by 1.5 cm
Weight when empty approx. 56 kg
Loading volume (depends on programme)
1)
max. 7 kg
Voltage 230 V
Required fuse 6 A
Total power 1050 W
Energy efficiency class A
Energy consumption (7 kg of cotton, pre-drained
at 1000 rpm)
2)
1.9 kWh
Average annual energy consumption 126.2 kWh
Use Domestic
Permissible ambient temperature + 5°C to + 35°C
Consumption values
The consumption values have been established under standard conditions. They may deviate when
the machine is operated in domestic circumstances.
Programme
Energy consumption in kWh / average drying
time in min.
COTTON CUPBOARD DRY
3)
1.9/ 135 (7 kg load pre-drained at 1000 rpm)
1.7 (7 kg load pre-drained at 1200 rpm)
1.65 (7 kg load pre-drained at 1400 rpm)
1.42 (7 kg load pre-drained at 1800 rpm)
COTTON IRON DRY
3)
1.4/ 106 (7 kg load pre-drained at 1000 rpm)
SYNTHETICS CUPBOARD DRY
3)
0.59/ 48 (3 kg load pre-drained at 1200 rpm)
1) different loading volume data may be needed in some countries as a result of different measuring
methods
2) in accordance to EN 61121
3) hints for test institutes: cycle has to be checked in accordance to EN 61121
electrolux 13