25981580 gb.
125981580 gb.qxp 2005-09-21 07:07 Page 2 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages After unpacking the machine please check it is not damaged. If in doubt, do not start it but contact your local Service Centre.
125981580 gb.qxp 2005-09-21 07:07 Page 3 These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Installation • •Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Centre. Always insist on genuine Electrolux spare parts. • This appliance is heavy. Care should be taken when moving it.
125981580 gb.qxp 2005-09-21 07:07 Page 4 Tips for environmental protection laundry and the required degree of dryness. To save energy and to help protect the environment, we recommend that you follow these hints: • Try to load the maximum capacity of the machine as small loads are uneconomical. • Always load well spun laundry. The higher the spin speed, the lower the electricity consumption and the shorter the drying times. • Do not over-dry laundry, this avoids creasing and saves energy.
125981580 gb.qxp 2005-09-21 07:07 Page 5 Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle.
125981580 gb.qxp 2005-09-21 07:07 Page 6 Installation Warning! When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. Unpacking Slide out the polythene bag with the polystyrene stuffing before using the appliance. Pull off adhesive strips from inside machine on top of drum Electrical connection This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.
125981580 gb.qxp 2005-09-21 07:07 Page 7 ENGLISH The Control Panel 5 1 2 3 4 6 7 1 Programme/Time Selector Dial 2 Display Allows you to select electronically controlled or time controlled drying. The DISPLAY is used for setting a large number of functions and combine them with each other using only a few control elements (1 programme selector dial and 6 buttons). This simple control method is made easy thanks to the interactive display.
125981580 gb.qxp 2005-09-21 07:07 Page 8 If you open the door during a programme, in order to restart the programme you must press the Start/Pause door. The button again after having closed the Half Power Yes 10.55 icon appears on the display above the Door Spin Options Change Exit relative button. 4 SPIN SPEED Button Press this button repeatedly to change the value of the spin speed. This value appears on the display above the relative button.
2005-09-21 07:07 Page 9 drying. This option cannot be selected with Quick Dry - press the START/ PAUSE closed the door. . ENGLISH 125981580 gb.qxp button, after having Half Load Quick By selecting this option the drying time is reduced in the following COTTON programmes: This option can be selected when the load inside the drum is less or equal to the half load weight declared by the programme selected.
125981580 gb.qxp 2005-09-21 07:07 Page 10 • when the small door at the bottom is open. To confirm this option press «Exit» button. Note! This option cannot be selected with the vocal messages and the icon Programme Stored has been disactivated. Temp. Spin Options Change Exit Set Up menu: Menu option is used for selecting various basic settings without affecting the particular drying programme. These basic settings will remain active until they are deselected/modified.
2005-09-21 07:07 Page 11 ENGLISH 125981580 gb.qxp Language You can change the language setting if you would like the indicators in the display to appear in a different language. Contrast Temp. Example: 1. Enter the Menu option and select the Language setting. Contrast Spin Options Change Exit Temp. Spin Options A Change Exit B Brightness Language ENGLISH Temp. Spin Options Change The Brightness setting allows you to modify the backlight intensity of the display. Example: 1.
5981580 gb.qxp 2005-09-21 07:07 Page 12 The appliance immediately stops drying, the «Pause» and «Please close condenser door» messages appear in the display also when the condenser door is opened. • messages indicating operational errors during the whole process. • warning messages. Check that you have loaded the laundry”; This button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted.
125981580 gb.qxp 2005-09-21 07:07 Page 13 Automatic drying (electronic programmes) Type of laundry Max-load (1) Degree of drying required Extra dry Ready to wear Store dry Slightly damp Iron dry Machine Iron Dry 6 kg 6 kg 6 kg 6 kg 6 kg 6 kg SYNTHETIC Extra dry Store dry Iron dry 3 kg 3 kg 3 kg JUMPERS Baby dry 1 kg (10 jumpers) COTTON Programme (*) (*) (*) (*) According to IEC 61121 Standards. • Baby Dry cycle is a special programme for jumpers to be dried “READY TO WEAR”.
125981580 gb.qxp 2005-09-21 07:08 Page 14 Operating Sequence Press the EXIT button to confirm the selection. Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes. There may be dust inside a brand new tumble dryer. Einstellungen Drying Temp. Spin Options Change 1. Connect the appliance. B 2. Open the door (see picture). All indicators on the display will appear in this language from now on.
2005-09-21 07:08 Page 15 8. Press the «Options» button to select the required options. To confirm your choice press the «Change» button. Depending on the selected programme only certain options are available and shown during the selection phase. Note: Not all the options are compatible between themselves. The incompatible option icons will disappear. after an other: «Please clean the filters» and «Please empty the tank». The buzzer sounds to indicate the end of the cycle. 11.
125981580 gb.qxp 2005-09-21 07:08 Page 16 Useful hints • Avoid drying dark clothes with light coloured fluffy items such as towels as they could attract the fluff. • Try to load to the maximum capacity of the machine as small loads are uneconomical. For information, here is a list of the average weights of some common laundry items. Sheet 700 - 1000 g Tablecloth • Easy-care items, too, e.g. shirts, should be briefly pre-spun before drying (depending on crease resistance approx.
125981580 gb.qxp 2005-09-21 07:08 Page 17 You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. After a while, a whitish patina due to detergent residue on laundry forms on the filters. When this occurs, clean the filters with warm water using a brush. Remove the filter in the door opening as per picture (it can be positioned with the tooth facing to the left or to the right).
125981580 gb.qxp 2005-09-21 07:08 Page 18 Clean it with a brush and rinse it under the shower if necessary. The reservoir must be re-inserted correctly. If this is not done the same message comes on during next drying and the programme stops, leaving the laundry damp. The buzzer will sound. After inserting the reservoir the START/PAUSE button has to be pressed again to allow the programme to continue. Handy tip: The condensed water may be used in a steam iron or to top up a battery, etc.
125981580 gb.qxp 2005-09-21 07:08 Page 19 Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that one of the following messages appears on the display: Problem with filters/condenser ......«Please clean filters/condenser» Please check filters/condenser. Problem with water reservoir ........
