User manual

ManualsBrandsElectrolux ManualsDryersEDC2086PDW

11. TROUBLESHOOTING

Problem Possible solution

You cannot activate the appliance. Make sure that the mains plug is connec-

ted to the mains socket.

Check fuse in fuse box (domestic installa-

tion)

The programme does not start. Press Start/Pause .

Make sure that the appliance door is

closed.

The appliance door does not close. Make sure that the installation of the filter is

correct.

Make sure that the laundry does not catch

between the appliance door and the rub-

ber seal.

The appliance stops during opera-

tion.

Make sure that the water container is emp-

ty. Press Start/Pause to start the pro-

gramme again.

The display shows a long pro-

gramme duration.

Follow guide in program table depending

on size and type of load

Make sure that the filter is clean.

The laundry is too wet. Spin the laundry in

the washing machine again.

Make sure that the room temperature is

not too warm.

The display shows a short pro-

gramme duration.

Set the Time Drying or the Extra Dry pro-

gramme.

The display shows Err. If you want to set a new programme, de-

activate and activate the appliance.

Make sure that the options are applicable

to the programme.

The display shows E51) Deactivate and activate the appliance.

Start a new programme. If the problem oc-

curs again, contact the Service.

After maximum 5 hours, the programme ends automatically

11.1 If the drying results are not

satisfactory

• The set programme was incorrect.

• The filter is clogged.

• The condenser is clogged.

• There was too much laundry in the ap-

pliance.

• The drum is dirty.

• Incorrect setting of the conductivity

sensor.

• The airflow slots are clogged.