EBGL70 ................................................ .............................................
www.electrolux.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 BEFORE FIRST USE . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.electrolux.com • Before maintenance cut the power supply. • Do not use harsh abrasive cleaners or sharp metal scrapers to clean the glass door since they can scratch the surface, which may result in shattering of the glass. • Only use the core temperature sensor recommended for this appliance. • To remove the shelf supports first pull the front of the shelf support and then the rear end away from the side walls. Install the shelf supports in the opposite sequence.
ENGLISH • The shock protection of live and insulated parts must be fastened in such a way that it cannot be removed without tools. • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. • If the mains socket is loose, do not connect the mains plug. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.
www.electrolux.com • Replace immediately the door glass panels when they are damaged. Contact the Service. • Be careful when you remove the door from the appliance. The door is heavy! • Clean regularly the appliance to prevent the deterioration of the surface material. • Remaining fat or food in the appliance can cause fire. • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
ENGLISH 7 Wire shelf For cookware, cake tins, roasts. Baking tray For cakes and biscuits. Core temperature sensor To measure how far the food is cooked. Glass dish with 2 grill inserts Sponge For absorbing residual water from the steam generator. 4. BEFORE FIRST USE WARNING! Refer to the Safety chapters. 4.1 Initial Cleaning • Remove all parts from the appliance. • Clean the appliance before first use. Refer to chapter "Care and Cleaning". 4.
www.electrolux.com Setting the time of day: 1. Touch or 2. Touch . 3. Touch or Changing the time of day to set hours. You can change the time of day only if the appliance is off. Touch . flashes in the display. To set new time of day use the above procedure. to set minutes. 4. Touch or . The Temperature / Time display shows the new time. 5. CONTROL PANEL 5.1 Electronic programmer 1 2 3 4 5 6 7 8 9 10 Use the sensor fields to operate the appliance.
ENGLISH Sensor Field Function Description 7 OK 8 LIGHT To activate or deactivate the lamp in the appliance. 9 CLOCK To set the clock functions. 10 MINUTE MINDER To set the minute minder. To confirm the selection or setting. 5.
www.electrolux.com 5.4 Heat-up indicator If you activate a heating function, the bars in the display come on one by one. The bars show that the temperature in the appliance increases or decreases. When the appliance is at the set temperature, the Heat-up indicator goes off the display. 6. DAILY USE WARNING! Refer to the Safety chapters.
ENGLISH Heating function Application 13 Half Steam + Heat For dishes with a high moisture content and for poaching fish, custard royale and terrines. 14 Full Steam For vegetables, fish, potatoes, rice, pasta or special side dishes. 6.1 Setting the heating function 1. Touch . The display shows a symbol, the number of the heating function and the preset temperature. 2. Touch function. 3. Touch or the appliance starts automatically after five seconds.
www.electrolux.com ator with the sponge. If necessary, clean the steam generator with some vinegar. Let the appliance dry fully with the door open. 6.6 Energy saving The appliance contains features which help you save energy during everyday cooking: • Residual heat: – When the heating function or programme operates, the heating elements are deactivated 10% earlier (the lamp and fan continue to operate).
ENGLISH 7.3 Setting the END 1. Touch display. . 13 and "00" flash in the 1. Activate the appliance and set a heating function and temperature. 2. 2. Touch again and again until the display shows . flashes in the display. Use or to set the MINUTE MINDER. First you set the seconds and then minutes and hours. 3. Touch and at the same time to reset the set time. 4. Touch or the MINUTE MINDER starts automatically after five seconds. When set time ends, an acoustic signal sounds for two minutes.
www.electrolux.com 4. 5. Touch or the settings save automatically after five seconds. The appliance starts. The display shows a symbol of the weight. During this time you can change the default or . Touch weight value with . 6. 7. When set time ends, an acoustic signal operates for two minutes. flashes. The appliance deactivates. Touch any sensor field to stop an acoustic signal. 9. USING THE ACCESSORIES WARNING! Refer to the Safety chapters.
ENGLISH 8. Touch a sensor field to deactivate the acoustic signal. Remove the core temperature sensor from the socket and remove the meat from the appliance. WARNING! Be careful when you remove the core temperature sensor. It is hot. There is a risk of burns. When you put the core temperature sensor into the socket, you cancel the settings for the clock functions. 15 When you cook with the core temperature sensor, you can change the temperature shown in the display.
www.electrolux.com • The high rim around the shelf is a device which prevents cookware from slipping. 10. ADDITIONAL FUNCTIONS 10.1 My Favourite Programme function Use this function to save your favourite settings of temperature and time for a heating function. 1. Set the temperature and time for a heating function or programme. 2. 3. Touch and hold for more than three seconds. An acoustic signal sounds. Deactivate the appliance.
ENGLISH Indicator of the setting menu Description Value to set SET5 SERVICE MENU --- SET6 RESTORE SETTINGS YES / NO 17 1) It is not possible to deactivate the tone of the ON / OFF sensor field. Activate the Settings menu: 1. When the appliance is deactivated, for three seconds. touch and hold The display shows "SET1" and "1" flashes. 2. Touch / 3. Touch . 4. Touch / of the setting. to set the setting. 5. Touch . 10.
www.electrolux.com • Clean all oven accessories after each use and let them dry. • If you have nonstick accessories, do not clean them using aggressive agents, sharp-edged objects or a dishwasher. It can cause a damage to the nonstick coating. 6. 7. 11.1 Steam cleaning 1. 2. 3. 4. 5. Remove the worst of the dirt manually. Put approximately 250 ml of water and 3 tablespoons of vinegar directly into the steam generator. Activate the appliance. Touch until the display shows .
ENGLISH 3. Installing the shelf supports Install the shelf supports in the opposite sequence. 11.3 Steam generation system CAUTION! Dry the steam generator after each use. Soak up water with the sponge. Remove the limescale residue with water and vinegar. CAUTION! Chemical de-scaling agents can cause damage to the enamel. Follow the instructions of the manufacturer. 2. 3. 4. 5. 19 Pull the support out of the rear catch. water drawer into the steam generator. Wait for approximately 10 minutes.
www.electrolux.com 3. 4. Close the door until it is at an angle of approximately 45°. Hold the door with one hand on each side and pull it away from the appliance at an upwards angle. Put the door with the outer side down on a soft and level surface to prevent scratches. 45° Inserting the door To insert the door do the above steps in the opposite sequence. 11.5 Lamp WARNING! Danger of electrocution! Disconnect the fuse before you replace the lamp. The lamp and the lamp glass cover can be hot.
ENGLISH Problem Possible cause 21 Solution The appliance does not heat up. The appliance is deactivated. The appliance does not heat up. The time of day is not set. Set the clock. Refer to "Setting and changing the time". The appliance does not heat up. The necessary settings are not set. Make sure that the settings are correct. The appliance does not heat up. The fuse is released. Make sure that the fuse is the cause for the malfunction.
www.electrolux.com 13. INSTALLATION WARNING! Refer to the Safety chapters. min. 3 mm To lift the appliance, do not use the door handle. 13.1 Installing the oven A = appliance N = recess B A A 180 A WARNING! Installation into flammable material must agree with NIN SEV 1000 (Swiss Association of the Cantonal Fire Insurance Companies) fire protection guidelines and regulations. ca.50 A 595 N 585-592 442 1. 115 CAUTION! Make sure the cable is free when you slide the appliance. N min.
ENGLISH 23 13.2 Installing the oven under a work surface Before the installation, connect the oven to the electrical supply. Refer to "Electrical connection". B 180 A A = appliance N = recess ca.50 A N 600 WARNING! Installation into flammable material must agree with NIN SEV 1000 (Association of Cantonal Fire Insurers) fire protection guidelines and regulations. A 595 442 115 CAUTION! Make sure the cable is free when you move the appliance. N min. 550 A 567 20 N 560-568 1.
www.electrolux.com Only a qualified person can connect the appliance to the electricity supply. D E 1. 2. 3. 4. F 5. 6. Open the mains terminal cover (D). Put the connection cable into the supplied rings (E). This is to prevent the cable from rubbing against the drawer. The connection cable is on the housing side. Install the cable grip (F). Connect the terminal as in the illustration. Put the cable into the strain relief clamp. Close the mains terminal cover. 13.
ENGLISH 25 14.1 Kundendienst, service-clientèle, Servizio clienti, Customer Service Centres Servicestellen Points de Service Servizio dopo vendita Point of Service 5506 Mägenwil/Zürich Industriestrasse 10 3018 Bern Morgenstrasse 131 1028 Préver6928 Manno enges Le Trési 6 Via Violino 11 9000 St. Gallen Zürcherstrasse 204e 4052 Basel St.
www.electrolux.com 15. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable and electronic appliances. Do not dispose appliances marked with the symbol containers to recycle it. Help protect the environment and human health and to recycle waste of electrical with the household waste. Return the product to your local recycling facility or contact your municipal office.
ENGLISH 27
892934989-D-422013 www.electrolux.
