User manual
33 electrolux troubleshooting
other features electrolux 34
ENG
ENG
Troubleshooting
Unit does not
start
The unit makes a
loud noise when
operating
Water on floor
- Make sure the dehumidifier s plug is pushed completely into the outlet.
- Check the house fuse/circuit breaker box.
- Dehumidifier has reached its preset level or bucket is full.
- Tank is not in the proper position.
- The air filter is clogged.
- The unit is tilted instead of upright as it should be.
- The floor surface is not level.
- Hose to connector or hose connection may be loose.
- Intend to use the bucket to collect water, but the back drain plug is
removed.
Dehumidifier
does not
dry the air as it
should
Frost appears on
the coils
E1, E2, P1 or P2
appear in the
display
- Do not allow enough time to remove the moisture.
- Make sure there are no curtains, blinds or furniture blocking the front or
back of the dehumidifier.
- The humidity control may not be set low enough.
- Check that all doors, windows and other openings are securely closed.
- Room temperature is too low, below 5 °C(41 °F).
- There is a kerosene heater or something giving off water vapor in the
room.
- This is normal. The dehumidifier has Auto defrost feature.
- These are error codes and protection codes. See the page 26.
PROBLEM SOLUTION
Bucket Full Light
Glows when the bucket is ready to be emptied, or when the bucket is removed
or not replaced in the proper position.
Auto Shut Off
The water level control switch shuts off the dehumidifier when the bucket is
full, or when the bucket is removed or not replaced in the proper position.
When the setting humidity is reached, the unit will be shut off automatically. For
some models,the fan motor will continue operating.
Auto Defrost
When frost builds up on the evaporator coils, the compressor will cycle off and
the fan will continue to run until the frost disappears. When Auto defrosting
operation,the unit may make a voice of refrigerant flowing,it is normal.
Auto-Restart (on some models)
If the unit breaks off unexpectedly due to the power cut, it will restart with the
previous function setting automatically when the power resumes.
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restart opertation in the first 3 minutes.
This is to protect the unit. Operation will automatically start after 3 minutes.
Smart dehumidifying mode(optional)
At smart dehumidifying mode, the unit will automatically control room humidity
in a comfortable range 45%~55% according to the room temperature. The
humidity setting function will be invalid.
Other features