User manual

1. Pull out the bucket a little
2. Hold both sides of the
bucket with even strenght,
and pull it out from the unit.
3. Pour the water out.
29 electrolux operation
operation electrolux 30
ENG ENG
Removing the collected water
There are two ways to remove
collected water.
1. Use the bucket
• When the unit is off,if the bucket is
full,the unit will beep 8 times and
the Full indicator light will flash, the
digital display shows P2.
• When the unit is on,if the bucket is
full, the compressor turns off and
the fan turns off after 30 seconds
for drying the water of the
condenser, then the unit will beep
8 times and the Full indicator light
will flash, the digital display shows
P2.
• Slowly pull out the bucket. Grip the
left and right handles securely, and
carefully pull out straight so water
does not spill. Do not put the tank
on the floor because the bottom of
the bucket is uneven. Otherwise
the bucket will fall and cause the
water to spill.
• Throw away the water and replace
the bucket. The bucket must be in
place and securely seated for the
dehumidifier to operate.
• The machine will re-start when the
bucket is restored in its correct
position.
When you remove the bucket, do not
touch any parts inside of the unit.
Doing so may damage the product.
Be sure to push the bucket gently all
the way into the unit. Banging the
bucket against anything or failing to
push it in securely may cause the unit
not to operate.
When you remove the bucket,if there
is some water in the unit you must dry
it .
2. Continuous draining
Water can be automatically emptied
into a floor drain by attaching the unit
with a water hose (not included).
• Remove the rubber plug from the
back drain hose outlet. Attach a
water hose(ID=13.5mm) and lead it
to the floor drain or a suitable
drainage facility.The drainage
facility should be lower than the
drain outlet of the unit.
• Make sure the water hose is secure
so there are on leaks.
• Direct the hose toward the
drain,making sure that there are no
kinks that will stop the water
flowing.
• Place the end of the hose into the
drain and make sure the end of the
hose is level or down to let the
water flow smoothly.Do never let it
up.
• Select the desired humidity setting
and fan speed on the unit for
continuous draining to start.
When the continuous drain feature is
not being used, remove the drain
hose from the outlet and attach the
rubber plug as shown.
Remove the
rubber plug
Attach the hose to
the drain hose outlet