Downloaded From WashingMachine-Manual.
Problem The door can not open : Spinning starts late or the laundry is not spun enough : Possible cause The program is still running and the drum is turning. The door lock has not yet released. The water level is above the bottom edge of the door. The machine is heating the water, and the water temperature is higher than 55 The door can only be opened when the relevant light has gone out. The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum.
Something not working? 3 14 15 - 17 4 18 4 Problems which you can resolve yourself During machine operation it is possible that one of the End light starts to flash: - E10:problem with the water supply - E20: problem with the water draining - E40:door open Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
6. Emergency emptying out Remove any objects from the pump impeller by rotating it. If the water is not discharged , proceed as follows to empty out the machine: Pull out the plug from the power socket; Close the water tap; If necessary, wait until the water has cooled down; Open the pump door; Place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl.Whe the bowl is full,put the cap back on the hose.
Maintenance Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the drawer after cleaning. 1. Door seal Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold. PE PS PP 4. Drain pump The drain pump should be inspected if The machine does not empty and/or spin. The machine makes an unusual noise during draining due to objects such as safety pins,coins etc. blocking the pump.
Programme table Type of laundry and symbols on labels 60 95 white cotton: Programme/ temperature Cottons 60-95 e.g. : work clothes, sheet,household 7 Description of programme Wash at 60-95 three rinses long spin linen, table cloth 60 30 Coloured cotton: e.g.shirts,blouse underwear towels household linen 60 30 Synthetic fabricand blends: e.g.shirts,blouse, underwear 40 30 Delicate fabric e.g.
60 90cm If you had selected the RINSE HOLDor NIGHT CYLCE option , the light of the START/PAUSE button goes out, the zero on the display begins to flash, the door is locked and RINSE HOLD or NIGHT CYCLE light remains lit. When the programme has been completed, a blinking zero appears on the display and the audible signal is given. Press the SKIP RESET button repeatedly to erase the programme that has just been carried out.
Important! Every programme has its limited temperature in order to preventing laundry from being spoiled,so it’s normal that some temperature can not be chosed. delay. The selected delay time value (up to 23 hours) will appear on the display for 3 seconds, then the duration of the programme will appear again. 7. Select the SPIN SPEED or the RINSE HOLD option Press the SPIN SPEED button repeatedly, in order to select the desired spin speed or the RINSE HOLD option. The relevant light will light up.
Operating sequence. Before washing your first load of laundry we recommend that you run a cotton cycle at 60 with the machine empty, in order to remove any manufacturing residue from the drum and tub. 1. Place the laundry in drum 5. Select the desired programme/ fabric Open the door. Place the laundry in drum, one item at a time,shaking them out as much as possible. Close the door. 1 2 3 4 5 6 8 7 9 Press the FABRICS button repeatedly, in order to select the desired programme/fabric.
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash 6-7 95 60 40 30 Max. wash temperature 95 C Max. wash temperature 60 C Max. wash temperature 40 C Max.
9 0 / Ink: depending on the type of ink, moisten the fabric first with acetone ( ), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. ( ) do not use acetone on artificial silk. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used.
Laundry weight Washing hints The following weights are indicative: Bathrobe Napkin Quilt cover Sheet Pillow case Tablecloth Towelling towel Tea cloth Night dress Ladies’ brief Man’s work shirt Man’s shirt Man’s pyjamas Blouse Men’s underpants Sorting the laundry Follow the wash code symbols on each garment label and the manufacture’s washing instructions. Sort the laundry as follows: Whites, coloureds , synthetics, delicates, woolens.
1200 100 700 500 200 250 200 100 200 100 600 200 500 100 100 95 60 30 -40 g g g g g g g g g g g g g g g In this case,both the drain and the spin (at the speed provided for the selected type of fabric) will be performed. This button allows you also to select special programmes, such as RINSES, SPIN and DRAIN.
The washing machine has completed the programme: this is indicated by a blinking zero. The zero will reappear when you switch the washing machine on, unless the previous programme has been erased by means of the SKIP RESET button. An alarm code indicates a fault in the machine operation . 9. START/PAUSE button This button has two functions: Start: after you have selected the desired programme and options, press this button to start the washing machine.
drain and spin: PREWASH: select this option if you wish your laundry to be prewashed before the main wash (not available for WOOL / HAND WASH and silk programme). The prewash ends with a short spin in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained. The PREWASH and the ANTI-ALLERGIC RINSE functions cannot be selected together. ANTI- ALLERGIC RINSE:can be used with all programmes except the WOOL / HAND WASH and SILK programme.
Use Control panel description 5 1 1 2 3 4 5 6 1. ON/OFF button 7 8 9 10 11 12 Sterilization 95 option can hold high temperature for 10 minutes, in order to eliminate microphyte from the laundry By selecting position COLD the machine will wash with cold water. To be used for extremely delicate items, such as curtains. Press this button to switch the washing machine on. Press the ON/OFF button again to switch the machine off. 2. MAIN-ON light This light is connected to the ON/OFF button.
Your new washing machine This new washing machine incorporates all the latest functions and wash technology from Europe and is built according to the highest manufacturing and quality standards, thus giving you optimal wash performance, lowest energy & water consumption and specially designed fabric care options: 7 10 SANITARY WASH 95 a special wash cycle that heats up water to high temperature and maintains it for more than 10 minutes will destroy most of all bacteria, thus ensuring healthy wash for you
When connect the waving junctures with inlet valve, please aviod leakage and loose for joint deviation of screw thread. Pay attention to avoid the damage for over-bending. Directly into a drain pipe at a height of not less than 60cm and not more than 90cm.The end of the drain hose must be always ventilated and the inside diameter of the drainpipe must be larger than the outside diameter of the drain hose. The drain hose must not be kinked.
7. Plug the open holes with the plugs, which you will find in the plastic envelope containing the instruction booklet. Installation Unpacking All transit bolts and packing must be removed before using the appliance. 60 95 You are advised to keep all transit devices so that they can be refitted if the machine ever has to betrantransported again. 1. Using a spanner, unscrew and remove the rear right-hand bolt and lay the machine to its back, taking care not to squash the hoses.
Disposal Packaging materials The materials marked with the symbol clable. PE PS PP When the appliance is to be scrapped, cut off the electrical supply cable and destroy the plug with the remaining cable. Disable the door catch in order to prevent children from becoming trapped . are recy- 1 polyethylene polystyrene polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. 4 Machine Use authorised disposal sites for you old appliance.
Warnings 6 Installation 7 Always unplug the appliance and shut the water tap after use. All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. Refer to the relevant paragraph in the instruction book. Any electrical work required to install the appliance must be carried out by a qualified electrician.
Contents Warnings 3 Disposal 4 Tips for environmental protection Technical specifications Installation 4 5 5 Positioning and levelling 5 Water inlet 5 Water drainage 6 Electrical connection 6 Your new washing machine Description of the appliance 7 Detergent dispenser drawer 7 Control panel Control panel description Washing hints 19 Bodywork 19 Detergent dispenser drawer 19 Drain pump 19 Water inlet filter 19 Emergency emptying out 20 Frost precautions 20 Something not working
Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, Check that it is not damaged. If in doubt, do not use it and contact the Service Centre.
Downloaded From WashingMachine-Manual.
