Manual

SettingSurface Controls
OPERATINGTHE DUALSURFACERADIANTELEMENTS
• • • • • • • • • • • • • • • • • • • • •
The cooktop isequipped with dual radiant surface element located at the right & left front
(See Figure 1 or 3) positions. Symbols on the knob are used to indicate which coil of the
dual radiant element will heat. The • symbol indicates that only the inner ceil will heat
(Figure 1). The ® symbol indicates that both inner and outer coils will heat (Figure 3). You
may switch from either coil setting at any time during cooking.
To Operate the Dual Surface Element:
1 Place correctly sized cookware on the dual surface
Figure1
I
Figure2 Figure4
Figure3
I
element
2 Push in and turn the control knob counterclockwise
(See Figure 2) for smaller cookware or clockwise
(See Figu re 4) for larger cookwa re.
3. Turn the knob to adjust the setting if needed. Start
most cooking operations on a higher setting and
then turn to a lower setting to finish cooking. Each
surface element provides a constant amount of heat
at each setting. A glowing red surface heating area
extending beyond the bottom edge of the cookware
indicates the cookware is too small for the surface
heating area.
4. When cooking has completed, turn the surface
control knob to OFF before removing the cookware.
Note: The Surface Indicator light will come on when
the control knob is turned on and will continue to
glow until the glass cooktop has cooled down to a
moderate level. The light may remain on even though
the controls are turned OFF.