Installation Guide

ManualsBrandsElectrolux ManualsMicrowave OvenIcon 1.5-cu ft Built-In Convection Microwave with Sensor Cooking Controls (Stainless)

CONVECTION MICROWAVE OVEN INSTALLATION INSTRUCTIONS

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

The electrical requirements for this oven are 115-120 volts AC, 15 amps or larger.

TINSEB472MRR0

Printed in United States

IMPORTANT - PLEASE READ AND FOLLOW

• Before beginning, please read these instructions completely and carefully.

• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.

Remove the turntable from the oven cavity.

• Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.

• Do not remove permanently afﬁxed labels, warnings, or plates from the product. This may void the warranty.

• Please observe all local and national codes and ordinances.

• The installer should leave these instructions with the consumer who should retain for local inspector’s use and for

future reference.

PARTS INCLUDED IN THE KITS

1) Front Frame Assembly

QTY 1

2) Bottom Duct Assembly

QTY 1

3) Screw A (

" length)

QTY 10

4) Screw B (1" length)

QTY 4

5) Screw C (1

" length)

QTY 2

6) Duct A (1)

QTY 1

7) Duct A (3)

QTY 1

8) Duct B

QTY 1

9) Duct C

QTY 1

Summary of content (4 pages)

PAGE 1
CONVECTION MICROWAVE OVEN INSTALLATION INSTRUCTIONS INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. The electrical requirements for this oven are 115-120 volts AC, 15 amps or larger. Important - Please Read and Follow • Before beginning, please read these instructions completely and carefully.
PAGE 2
CONVECTION MICROWAVE OVEN INSTALLATION INSTRUCTIONS F H NOTE: 1. Base must be capable of supporting 200 pounds (90.7 kg). A 2. Make sure base is level and front of cabinet is square. If the cabinet base is not level, the oven will tend to slide out when opening the door. B D 3. Provide an opening in the wall or cabinet as indicated in Illustration 1. The depth should be a minimum of 20 1/8" (51.1 cm).
PAGE 3
CONVECTION MICROWAVE OVEN INSTALLATION INSTRUCTIONS EXHAUST DUCT ASSEMBLY 1. Insert the edge of DUCT (B) into the hold lip of DUCT (C). Secure together by using a SCREW (A) provided in the kit. Remove the existing screw (#1) at upper right rear of the oven and secure DUCT (C) with the screw (#1) just removed from the oven. Secure DUCT (B) with SCREW (A) through the duct and into the original screw hole in the oven. See illustration 2. 3.
PAGE 4
CONVECTION MICROWAVE OVEN INSTALLATION INSTRUCTIONS CABINET INSTALLATION 1. Place the oven adjacent to the wall or cabinet opening. Plug the power cord into the electrical outlet. See Illustration 7. Avoid pinching the cord between the oven and the wall. Adjust the position of the oven so that the feet of the oven are fitted into the recesses of the Bottom Duct Assembly. See Illustration 8. 2. Carefully guide the assembled oven into the prepared opening. Slide the oven on the Bottom Duct Assembly.