Installation guide

ManualsBrandsElectrolux Manualswall ovenOfficial Electrolux wall oven

6. Cabinet Installation

Heavy Weight Hazard

• Use 2 or more people to move and install wammoven.

• Failure to folmow this instructions can resumt in injury

or damage to the unit.

The wall oven can tip when the door

is opened. The mounting brackets supplied with

the wall oven must be attached to the cabinet and

the appliance to prevent tipping of the wall oven

and injury to persons.

Mounting Bracket installation instructions

1.Find the 2 mounting brackets and screws included in

the literature package.

2.Install the mounting brackets in the cabinet as shown on

figure 8. Note: To prevent damage to cabinet, it is

recommended to drill I/16" (0.16 cm) dia. pilot holes

before installing the mounting brackets.

_ 5ingle Oven see Fig. 1 _Double Oven see Fig. 2

Mounting a

Brackets H

Single Oven see Fig. 1

Single Oven: Double Oven see Fig. 2

23 I/4" (59.1 cm)

a Double Oven:

gg 46Y2" (118.1 cm)

i....l_....,.............

Figure 8

3. Insert the unit into the cabinet opening. Slide unit inward

leaving 3" (7.6 cm) clearance between the oven and

front of cabinet (Figure 9). Pull the armored cable

through the hole in the floor and toward the junction box

while moving the appliance inward.

4. Install now the bottom trim using the screws supplied

withthe unit (Figure 10).

5.Push the unit in and against the cabinet, then the oven

side bracket will clip in the one you just install on the side

of the cabinet opening.

To pull out the oven for servicing insert the tool supplied

with the appliance both side at the same time in the hole

located on the side frame and visible when the door is

opened. After inserting the tool pull the oven towards

you (see figure 11).

6. For typical under counter installation of an electric built-in

oven see Figures 12 and 13.

Figure 9

Oven

_racke_._

-_" 3" (7.6 cm)

clearance between unit

and front of cabinet

Figure 10

Mounting

bracket installed

Cabinet

Right Side

_1_ Tool

.....supplied

iii_i!i_ili!!i/

Mounting

bracket released

Oven removed from

the cabinet

Hole where to insert

the tool

Figure 11