Manual
FigureI
Care & Cleaning
5_
As soon as the control is set, the motor driven oven door lock will
begin to close automatically. Once the door has been locked the
"DOOR" and "LOCKED"indicator light will stop flashing and remain on.
Also, the oven icon will appear in the display (Figure 1). Allow about
15 seconds for the oven door lock to close.
Note: If the optional delay Self-Clean feature is needed, finish steps 6-9. If Self-
Clean is started immediately skip the remaining steps and continue with "When the
Self-Clean cycle is completed".
Figu re2
Figu re3
Figure4
Figure5
Figure6
6. Press (_ or (_. "UPPER"and "DELAY" will start flashing and "--:- -"
will appear in the display (Figure 2).
7. Enter the desired start time using the number pads (_), (_, (_
(Figure3).
8. Press ___. The display will return to the time of day (Figure 4).
X
$'TART
9. The control will start the self-cleaning at the set start time, for the
period of time previously selected (Figure 5).
When the Self-Clean Cycle is Completed:
1. Three long beeps will be heard and "CLn"will disappear from the
display. "UPPER", "DOOR" and "LOCKED" will remain in the display
until the door is unlocked. The cooling fan will continue to run until the
oven has cooled down (Figure 6).
2. Once the oven has cooled down for 1 HOUR, and "UPPER","DOOR"
and "LOCKED"are no longer displayed, the oven door can then be
opened.
Stopping or Interrupting a Self-Cleaning Cycle:
If itbecomes necessary to stop or interrupt a self-cleaning cycle due to
excessive smoke in the oven:
1. Press@or@.
2. Once the oven has cooled down for approximately 1 HOUR and "UPPER", "DOOR"and
"LOCKED" are no longer displayed, the oven door can then be opened.
Important Notes whenusingthe Self-Clean Feature:
1. A Self-Clean cycle cannot be started if Oven Lockout feature is active.
2. When Self-Clean cycle is active on one oven, the other one cannot be used or set for a
Self-Clean cycle or any cooking.
3. If your clock is set for normal 12 hour display mode the delay Self-Clean cycle can
never be set to start more than 12 hours in advance. To set for a delayed Self-Cleaning
cycle 12-24 hours in advance see instructions to set the control for the 24 hour time of
day display mode.