Manual

::: en:lnguven L;omrols
SETTINGTHECLOCK
The
or _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of
day operation. The clock is preset at the factory for the 12 hour operation. When the wall
oven is first plugged in or when the power supply to the wall oven has been interrupted, the
display will flash "PF" (power failure, See Figure 1).
When "PF" appears in the display, press @ or @. A beep will sound and "PF" will
r.&N_L _CmL
disappear.
To set the clock (example below for 1:30):
1. Press (_) or (_). "CL0" and the current time of day will appear in
the display (Figure 2).
2. Press (_) (_) (_) pads to set the time of day to 1:30 (Figure 3).
Press (_). The time of day will appear in the display (Figure 4).
8T_T
Changing between 12 or 24 hour time of day display:
0 orQ for6seconds(F gure3/."C'O"andthe
1. Press and hold
current time of day will appear in the display (Figure 2). A beep will
sound and "12h" (Figure 5) or "24h" (Figure 6) will appear in the
display.
O or (_) to switch between the 12 and 24 hour time of day
2. Press
display. The display will show either "12h" (Figure 5) or "24h" (Figure
6).
3. Press (_) to accept the change or press @ or @ to reject the
&TART _ _mCEL
change.
4. Reset the correct time as described in To set the Clock above,
Please note that ifthe 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6