Specifications

@I I I iilll_ @II,,,,,III I _WII I IWII,,,,,, WIF°IIR I IWII
m [] [] [] [] m [] m m [] m [] [] m [] m [] m m [] m []
The _ or f"(,!--i.,)and _ or _) pads controHthe Slent ControHoperalon feature. The
Slent ControHoperaton feature aHHowsthe oven controH to be operated without sounds or
beeps whenever necessary. Hfdesired the controH can be programmed for slent operalon
and Haterreturned to operalng with aHHthe normaHsounds and beeps.
To change control from normal sound operation to silent control
1. To tell if your range is set for normaHor silent operalon press and hold @ or
for 7 seconds. "0:00" wlH appear in the dispHay (Figure 1).
2. Press @ or @ to switch between normaHsound operalon and slent
operalon mode. The dispHay wlH show either ":SP" (Figure 2) or ":--" (Figure 3).
If ":SP" appears (Figure 2), the control will operate with normal sounds and
beeps. Hf":- -" appears (Figure 3), the controH is in the siHentoperation mode.
Press (_) or @ to accept the change or press (_) or @ to reiect the change.
_TART C_CEL
ADJUSTINGOVENTEMPERATURE
m [] [] [] [] m [] m m [] m [] [] m [] m [] m m []
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures. If you think the oven is too hot or too cool,
the temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The
baking results should help you to decide how much of an adjustment is needed.
To adiust the oven temperature:
1. Press @ or @ for 8 seconds (Figure 4).
2. To increase the temperature use the number pads to enter the desired change.
(Example 30°F) (Z) @ (Figure 5). The temperature may be increased as
much as 35°F (17°C). To decrease the temperature use the number pads to
enterthe desiredchange. (ExampHe -30°F)@ @ and then Press @ or
"'9 (Figure The be decreased much as 35°F (17°C}.
6). temperature may
as
3. Press (_)0,=,or 6,,) to accept the temperature change and the display will return
to the time of day (Figure 7). Press (_)o=o=or _D to reject the change
if
necessary.