Manual

toCommon
OVEII COM=BOL BEEPS AID DISPLAYS FI THROUGH FSO
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Electronic control has detected a fault condition. Push CANCEL pad to clear the
display and stop the display from beeping. Reprogram the oven. If a fault reoccurs,
record the fault number, push the CANCEL pad and contact an authorized sen,,icer.
IB IllsDISP/AVED
m [] m [] [] m [] m [] m [] [] m [] [] m [] [] [] m m []
The door was left open and controls set for self-cleaning cycle. Close the door and
push both upper and lower oven CANCEL pads.
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Place oven rack in center of oven. Place a level on the oven rack. Contact installing
agent if rack and cabinet cutout flooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets
are square and level. Contact cabinet maker to correct problem.
ENTIREOVEN DOES NOT OPERATE
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display wiii flash. The oven cannot be programmed until the clock is
set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not suppled with oven. Contact
your dealer, installing agent or authorized servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized
sewicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.