Installation guide

5. Checking Operation
If your model is equipped with an Electronic Oven
Control, Each of tile functions has been factory checked
before shipping. However, it is suggested that you verify
the operation of tile electronic oven controls once more.
Refer to tile Use & Care Guide. Follow the instructions
for the Clock, Timer, Preheat, Bake, Broil Convection
and Clean functions.
Bake-After setting the oven to 3BO°F/177°C for baking,
tile lower element in the oven should become red.
Broil-When tile oven isset to BROIL, the upper element
in the oven should become red.
Clean-When the oven is set for a self-cleaning cycle, the
lower element will become red.
Convection-When the oven is set for a convection,
Convection element located at rear of the oven will turn
on.
IMPORTANT NOTE: A fan inside tile oven will turn on as
soon as the oven is operate.
Model and Serial Number Location
The serial plate is located inside the oven on the side
trim.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
Before You Call for Service
Read tile Avoid Service Checklist and operating
instructions in your Use & Care Guide. It may save you
time and expense. The list includes common occurrences
that are not the result of defective workmanship or
materials in this appliance.
Refer to the warranty in your Use & Care Guide for our
toll-free service number and address. Please (:all or write
if you have inquiries about your product and/or need to
order parts.