Installation guide

4. Cabinet JnstaJNation
Heavy Weight Hazard
Use 2 or more peopJe to move and install wa[[ oven.
Failure to follow this instructions can result in injury or
damage to the unit.
The wall oven can tip when the door
is open, The mounting brackets supplied with the
wail oven must be attached to the cabinet and the
appliance to prevent tipping of the wall oven and
injury to persons,
Mounting Brackets installation instructions
1.Unpack the wall oven and find the 2 mounting
brackets and screws in(luded in the literature package.
2.Install the mounting bracket in the cabinet as shown on
figure 4. Note: To prevent damage to cabinet, it is
recommended to drill I/1 6" (0.1 6 cm) dia. pilot holes
before installing the mounting brackets.
Cutout Dimensions
kk
wlounung _ 28 I/4"
Brackets
_(718 cm) Min.
23 1/4" _ 28 7/8"
(59.1crN
I
I I
L ........ a},........... I
* Recommended
Cutout Width is 28_"
(72,4 cm)
Figure 4
3. Insert the unit into tile cabinet opening. Slide unit inward
leaving 1 1/2" (3.8 cm) clearance between the oven and
front of cabinet (seeFigure 5). Pull tile armored cable
through the hole in the floor and toward the junction box
while moving the appliance inward.
4.Push tile unit in and against the cabinet, then the oven
side bracket will clip in the one you just install on the side
of the cabinet opening (see figure 6).
To pull out the oven for servicing insert the tool supplied
with tile appliance both side at the same time in tile hole
located on the side frame and visible when the door is
opened. After inserting the tool pull tile oven towards
you (see figure 7).
5. For typical under counter installation of an electric builtdn
oven see Figure 8.
f
Oven
1 I/2" (3.8 cm)
clearance
b_tween unit
Figure 5
Figure 6
Right Side
Mounting
_racketreleased
_J N
Oven removed
from the cabinet
Hole where to insert
the tool
Figure 7